耐热防锈底漆600℃,NR616-1.docVIP

Intended Uses 用途 一种耐600℃底漆，适用于发动机，锅炉，排气管道等作底漆之用。 As primer resistance to temperature high to 600℃,suitable motor boiler, and exhaust pipeline etc.as primer. Product Information产品简介 双组份，有机硅树脂漆。有限颜色（铁红、铬黄等） Two packages, Pased on silicone resin. Some colors may be chosen Such as Iron red, and Chromate yellow etc. Application details 产品数据 Volume Solids 固体份 ≥46% Dry Flm Thickness干膜厚度 23microns, equpvalent to 50 microns of wet film 23微米相当于50微米湿膜厚 Theoretical Coverage 理论涂布率 11m2 /Kg 11平方米/公斤 Practical Coverage 实际涂布率 Allow appropriate loss 允许适量损耗 Storage and Handling 施工详述 Mix Radio 混合比 A:B 100:0.8（by weight） 甲：乙 100：0.8 Method of Application 施工方法 Airless Spray 无空气喷涂 Recommended 推荐采用 Brush or Roller 涂刷或辊涂 Suitable 适用 Conventional Spray 传统喷涂 Recommended 推荐采用 Thinner 稀释剂 C002 Cleaner 油漆设备清洗设备 C002 Pot Life 使用期 25℃: 12hour 小时 Storage 贮存期 One year 一年 Drying time 干燥时间 Substrate Temperature 底材温度 Touch Dry 表干 （min） Hard Dry 硬干 （h） Over coating Interval 覆涂间隔 Mix最短 Max最长 10℃ 25℃ 35℃ 2.5 1.5 1 48 36 25 24hours小时 14days天 Storageand Handling 贮存与管理 Storage 贮存 Store in cool and dry conditions 贮存于阴凉干燥处 Pack size 包装规格 A:25Kg in 20 liter container 25公斤装于20公升容器中 B:200g in a litter bottle 200克装于一小瓶中 Flash Point 闪点 ＞24℃ Specific Gravity 比重 1.3-1.5Kg/L 1.3-1.5公斤/公升 Specification and Surface preparation 技术要求及表面处理 Wash Substrate should be blasted or rust-removed manually near to white Wash the surface with cleaner. The surface must be free from dirt such as grease, and salt etc Surface to be applied must be clean and dry. 底材喷砂处理或手工除锈近乎出白 用清洗剂清理表面，无污物（如油污、油脂、盐类等） 在施工前应保持表面清洁、干燥。 Safety Precautions 安全措施 This product should be used in painting area by perfessional operators. When painting , please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product. This product is a kind of solvent-based paint .Inorder to avoid danger or accident, min