Contact Models研讨.docxVIP

Contact Models接触模型A?contact model?describes how elements behave when they come into contact with each other. Using the Interaction pulldown menu and?+?pick-list, you can build a list (stack) of contact models. The top element is applied first, then the next one down and so on. Use the up and down buttons to move the contact model up and down the list (check the sections below since some models need to be at the start or end of the list). To remove an item, click the?x?button. Click the preferences button to configure the selected model.（接触模型描述了元素间的接触行为。使用Interaction下拉列表和按钮“+”来添加一系列接触模型。EDEM优先采用列表中的最前列的接触模型，优先级依次下移。用户可以使用up和down按钮来上下移动列表中接触模型的排列。点击按钮“X’’来删除列表中的模型。点击Configure按钮来设置所选中接触模型的参数配置。）Every simulation must have at least one base particle-to-particle and one particle-to-geometry contact model.?EDEM is supplied with several integrated contact models; you can also add your own custom plug-in contact models. Refer to?the user section of the DEM website?and theEDEM Programming Guide?for details.（所有仿真必须至少包含一个基础的颗粒-颗粒和颗粒-几何体接触模型。EDEM提供了几个可选的接触模型，你也可以添加自定义的接触模型插件。更多细节的查询可以到DEM用户网站查询）Hertz-Mindlin (no slip)（Hertz-Mindlin无滑动接触模型）Hertz-Mindlin (no slip)?is the default contact model.（EDEM中默认的接触模型）?Interaction相互作用Configurable Parameters参数的设置PositionParticle to ParticleNoneLastParticle to GeometryRecord Relative Wear (On / Off)The Relative Wear model is a way of identifying regions of high impact (normal) and abrasive (tangential) wear on the equipment within a simulation. It is calculated based on the relative velocity and associated forces between the bulk material and the equipment. This model provides the user with additional data to indicate regions in which wear is taking place. Whilst it provides quantitative values for comparison between two or more design iterations, it does not determine an explicit material removal rate.相对磨损的记录（开/关）相对磨损是一种识别仿真中设备的高冲击（法向）和磨损（切向）区域的方法。这种方法是基于疏散物料与设备的相关力和相对速度计算的。这个接触模型提供用户额外的数据来表征相对磨损发生的区域。与此同时，这种计算方法提供了两次及两次以上的仿真设计数值的对比，但是并不能精确的计算