船舶制造必备英语日常用语1000句.docVIP

船舶制造英语日常用语 好东西大家分享啊船舶制造英语日常用语一．? ? ? ? 船体1．? ? ? ? You must weld and grind this area before painting.在油漆之前你必须把这个地方电焊修补、打磨好。? 2．? ? ? ? This welding line should be gouged and welded again before tightness inspection.这条焊缝在密性检查前要碳刨、再焊。3．? ? ? ? The structure of the starboard side is different from the port side.右舷的结构跟左舷的不一样。4．? ? ? ? We should reinforce the downside of the windlass.我们应该在锚机的反面加强。5．? ? ? ? The navigation deck is not plain,? we will fair the deck by hot working.驾驶甲板不平，我们要火工校正。6．? ? ? ? There are two pieces of stiffeners and brackets must be replaced.有两块加强筋和肘板要换新。7．? ? ? ? Two more footrests and handgrips should be installed at the entrance of the small hatchcover.在小舱口盖的进口处再安装两只踏步和拉手。8．? ? ? ? Checking the joint accuracy and structure integrity between No.8 and No.9 block after closed.No.8 与No9分段合拢后大接头装配精确性和结构完整性检查。9．? ? ? ? Checking structure integrity of superstructure(deckhouse)after welding.上层建筑焊后结构完整性检查。10．? ? ? ? Inspecting fitting accuracy of hatch coaming on board.货舱口围板船上安装精度检查。11．? ? ? ? Inspection air pressure test(with water head) for No1. water ballast tank(No15 block).No1压载水舱（No.15分段）气压试验（压头试验）检查。12．? ? ? ? Inspection hosing test for upper deck.上甲板冲水试验检查。13．? ? ? ? Measuring hull’s main dimensions: length overall(LOA.),length between perpendiculars(LPP.),breath molded(B.),depth molded(D.) and deflection before launching.下水前测量船体主尺度：总长、两柱间长、型宽、型深、基线挠度。14．? ? ? ? Inspection distance between draught marks and keel plate after marking out.划线后检查吃水标尺至平板龙骨之间的距离。15．? ? ? ? Inspecting fitting accuracy of draught mark(loading line mark).吃水标志（载重线标志）安装精确性检查。16．? ? ? ? Inspection welding seam and dimension of cargo hatch cover.货舱舱口盖焊缝和尺度检查。二．? ? ? ? 轮机1．? ? ? ? Inspection machining dimension of propeller shaft(intermediate shaft or counter shaft).螺旋桨轴（中间轴）机加工尺寸检查。2．? ? ? ? Check for surface contact area(metallic contact) between stern shaft and propeller hub tapers. 检查螺旋桨轴与螺旋桨锥度接触面。3．? ? ? ? Inspection machining di