5000m3油罐安装施工方案.docVIP

适用范围Applicability 本方案适用于水泥项目5000m3油罐现场组装全过程。 This method statement applies to cement plant project 5000m3 oil tank overall assembly and erection on site. 工程概况General 工程内容：5000m3立式拱顶油罐座（罐体对接焊普通拱顶） Project content: 5000 m3 vertical vault oil tank. (common vault and butt weld for the tank) 工程范围：油罐现场成形组对、焊接、检验以及罐体附件安装。 Project cope: oil tank site assembly, welding, inspection and installation of tank accessories 罐体直径24000mm，壁高12000mm，立式拱顶，拱顶厚6mm,罐壁厚6mm、8mm、10mm、12mm,底板厚6mm，罐体上有环形楼梯，罐顶有栏杆，罐内有加热管等。 The tank diameter 24000mm, wall high of 12000mm, vertical vault and the vault thickness is 6 mm. tank thicknesses is 6mm, 8mm, 10mm and 12mm.bottom thickness of 6mm. there are circular stairs, handrails on top and heating tubes inside the tank etc. 编制依据Reference Document TCDRI提供的施工图纸及技术要求； Erection drawing and technical requirement provided by TCDRI. 我公司现场施工设备； Erection equipment of our company on site  主要施工工序描述describe the main construction process 基础检验Foundation acceptance 用钢卷尺、水准仪检查基础标高。基础中心标高允许偏差±20mm，每10m弧长内任意两点高差不大于6mm，且整个圆圈内高差不大于12mm。 Using steel tape and level to check foundation elevation, foundation center elevation allowable tolerance is ± 20mm, the height difference of two points at random selection of every 10m arc length should be less than 6mm, and the height difference in whole circle should not more than 12mm. 沥青砂层表面应平整密实，无突出的隆起，凹陷及贯穿裂纹，沥青砂层表面凹凸度按下列方法检查：从基础中心向基础周边拉线测量，基础表面每100m2范围内测点不少于10点，基础表面凹凸度允许偏差不得大于25mm。 Asphalt sand layer surface should be flat and compact, no prominent bulge, sag and through crack. The asphalt sand layer surface degree check is as the following methods: tagline survey from foundation center to surrounding, the measuring points of foundation surface per 100m2 scope should not less than 10 points, the tolerance of foundation surface convexo-concave degree should not exceed 25mm. 基础放线Foundation setting out 划基础圆心及基础底板外圆。 Marking foundation circle center point and foundation bottom external circle center. 基