Solder checking standard——焊接检查标准.docVIP

名称: Solder checking standard 焊接检查标准 文件编号 审查 核准 制定部门 适用部门 C L: 版本: Purpose/目的 (1) For solder instruction standard/作为焊接作业遵循的标准 (2) According as creating SOP/作为标准操作规程制定依据 (3) For QC checking/作为QC 检查依据 Reference Documents /参考文件 IPC-A-610D Scope/范围 This document is valid withinfor PCBA Soldering /适用于 PCBA焊接检查. Description/内容 NO序号 item/项目 Picture/图示( PASS) Picture/图示(NG) 1 Minimum End Joint Width 最小末端焊点宽度 (PASS) (NG) End joint width is equal to or greater than lead width 末端焊点宽度等于或大于引脚宽度. Minimum end joint width is less than 50% lead width(W) 最小末端焊点宽度小于引脚宽度的50% 2 Minimum Side Joint Length 最小侧面焊点长度 (PASS) (NG) Evidence of wetted fillet along full length of lead 引脚全长焊点润湿 The minimum side joint length(D) is less than three lead widths( W) or (D) is less than 75%(L) 最小焊点长度D 小于3 倍引脚宽度W 或75%引脚长度 Width to height ratio does not exceed two to one(2:1) ratio 宽度对高度的比例不超过二比一(2:1). Complete wetting at land or end cap metallization 焊盘和元器件可焊端表面完全润湿. Width to height ratio exceeds two to one(2:1) ratio; Incomplete wetting at land or end cap metallization; Less than 100% overlap of the componet termination and the land 元件宽度与高度之比大于2:1；元件焊接端与焊盘未完全润湿；元件端头与焊盘重叠小于100%； (PASS) (NG) Evidence of wetted fillet along full length of lead 引脚全长焊点正常润湿 Toe overhang violates minimum electrical clearance 元件脚趾部违反最小电气间隙（0.13mm) 4 Rectangular or square End 长方体元件偏移 (片式元件侧面偏移) (PASS) (NG) No side overhang 无侧面偏移 Side overhang is greater than 25% component termination width or 25% land with, whichever is less. 侧面偏移大于元件可焊端宽度的25%或焊盘宽度的25% 5 Mounting Upside Down 翻面 (PASS)