游泳池涂料的特点和施工.docVIP

Intended Uses 用途 可用于铁制或混凝土制的游泳池，蓄水池（非饮用水）的涂装，可防止渗水，可防止腐蚀或风化，耐水浸泡和干湿交替、还可防止藻类生长。 Suited for painting swimming pool and water tank made with steel or concretes. The coat and prevent is Seeping. Corroding and weathering with water soaking and humid-dry cycling resistance even avoid algae growing. Product Information产品简介 Various 各色 Application details 产品数据 Volume Solids 固体份 40-50% According to the color 40-50% 与颜色有关 Dry Flm Thickness干膜厚度 50-60microns 50-60微米 Theoretical Coverage 理论涂布率 5.6-7.1m2 /Kg According to the color and D.F.T 7.9平方米/公斤 视干膜和颜色而定 Practical Coverage 实际涂布率 Allow appropriate loss 允许适量损耗 Storage and Handling 施工详述 Mix Radio 混合比 One packgae 单组份 Method of Application 施工方法 Airless Spray 无空气喷涂 Recommended 推荐采用 Brush or Roller 涂刷或辊涂 Recommended 推荐采用 Conventional Spray 传统喷涂 Not Recommended 不推荐采用 Thinner 稀释剂 C001 Cleaner 油漆设备清洗剂 C001 Pot Life 使用期 Not limit 无限制 Storage 贮存期 One year 一年 Drying time 干燥时间 Substrate Temperature 底材温度 Touch Dry 表干 （h） Hard Dry 硬干 h） Over coating Interval 覆涂间隔 Min最短 Max最长 25℃ 0.5 24 8 hours 小时 Not limited 无限制 Storage and Handling 贮存与管理 Storage 贮存 Store in cool and dry conditions 贮存于阴凉干燥处 Pack size 包装规格 25Kg in 20 liter container 25公斤装于20公升容器中 Flash Point 闪点 38℃ Specific Gravity 比重 1.25-1.35Kg/L 1.25-1.35公斤/公升 Specification and Surface preparation 技术要求及表面处理 The steel surface to be applied: Blast to Swedish Standard Sa2.5 or rust-removed manually or with power tool to St3. Then paint primer. The surface should be clean and dry. The concrete surface: Must cured completely. The surface should be clean and dry 钢材表面：喷砂除锈至瑞典标准Sa2.5级或手工或动力工具除锈至St3, 然后涂装底漆，表面保持清洁干燥。 混凝土：充分熟化，表面清洁干燥。 Safety Precautions 安全措施 This product should be used in painting area by professional operators. When painting , please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product. This product is a kind of solvent-b