sample of tune-up procedure(手机RF测试).docVIP

Tune Up Procedure Tune-up procedure GSM GPRSWIFIBT TEST Measurement Procedure: GSM Connect EUT with CMU200 through RF cable.（通过RF线连接EUT（测试样品）和CMU200（终测仪）） Make a call from CMU200.（从CMU200带电话出去） After setup a call,Set Power Level to 5 for GSM850 and 0 for PCS.（完成电话设置后，为GSM850设置功率级别到5并且PCS到0） Measure the Output Power AV value. （评估AV的输出功率值） GPRS Connect EUT with CMU200 through RF cable. Enter engineering mode by dialing Number *#*#座机电话号码#*#*（按工程模式码） Select options 选择选项 :”telephony”-----GPRS ----Attach Start the test.（开始测试） WIFI Connect EUT with IQ2010 through RF cable 2.Enter engineering mode by dialing Number *#*#座机电话号码#*#* 3.Select options one after another:RF test tool----“connectivity”---WIFI---TX test---Tx output power 4.Start WIFI test Bluetooth Connect EUT with CMU200 through RF cable Enter engineering mode by dialing Number *#*#座机电话号码#*#* Select options one after another:RF test tool Start Bluetooth test. Remarks: All Output Power are tested in Average Value specification （批注：所有的输出功率是平均值） 注： 请按照贵公司的实际手机信息完成。 标黄的部分为注意 标绿的部分为翻译 Table 1: GSM Speech Target Value is Average Output Power Value GSM 900 Channel Channel 975 Channel 124 Channel 30 Target dBm （规定标准值） 32.5 32.5 32.5 Tolerance ± dB （公差） 2 2 2 GSM 1800 Channel Channel 884 Channel 699 Channel 513 Target dBm 30 30 30 Tolerance ? dB 2 2 2 Table 2: GPRS GMSK Modulation Target Value is Average Output Power Value GSM 900 GPRS Channel 975 124 62 1 Txslot Target dBm 32.5 32.5 32.5 Tolerance ? dB 3 3 3 2 Txslots Target dBm 31.5 31.5 31.5 Tolerance ? dB 3 3 3 3Txslots Target dBm 30.5 30.5 30.5 Tolerance ? dB 3 3 3 4 Txslots Target dBm 28.5 28.5 28.5 Tolerance ? dB 3 3 3 GSM 1800 GPRS Channel 884 699 513 1 Txslot Target dBm 29.5 29.5 29.5 Tolerance ± dB 3 3 3 2 Txslots Target dBm 28.5 28.5 28.5 Tolerance ± dB 3 3 3 3Txslots Target dBm 27.5 27.5 27.5 Tolerance ± dB 3 3 3 4 Txslots Target dBm 25.5 25.5 25.5 Tolerance ± dB 3 3 3 Table 3: WCDMA