工程师技能考试题目.docVIP

Raw material capacity 1. Where you can find Drying Capacity calculator. 哪里可以找到干燥容量计算? A) From your supervisor. 通过主管 B) From LSS Raw Material Drying Capacity Calculator COR 07.13.01-07.2.xls 从LSS Raw Material Drying Capacity Calculation COR 07.13.01-07.2.xls 文件中 C) From molding tool folder. 从模具文件夹中 2. A) What difference is between hot and dry air dryer? 热风干燥机与空气干燥机的区别? Hot air dryer.热风干燥机 Drying with hot air. Humidity % as same as environment. 使用热风干燥,湿度百分比与大气环境的一致 Dry air dryer. 空气干燥机 Drying hot and dryed air (condensation temperature -20 °C or less .what means relative humidity % what is in -20°C air. 将空气干燥,温度至少在零下20度,也就是说在相对湿度为零下20度的空气中. B) Which dryer type drying raw-material more efficiency? 哪种干燥机的效率高? Dry air dryer.空气干燥机 3. You run production from Pc + Abs Sabic C1200HF and you see that injection pressure is lower what is in optimized process parameters. What follow reason perhaps is main factor. 用PC+ABS Sabic C1200HF原料生产时,会发现注射压力要比最优化工序参数的低,下面哪项是主要因素? A) Too low moisture % 湿度过低 B) Too high moisture % 湿度过高 C) Injection pressure not have effect to part. 注射压力对产品无影响 4. You use Aboni FMX hydrotracer for measuring moisture %. What you do with reagent material after use. 使用Aboni FMX hydrotracer来测试湿度,如何处理使用过的试剂? A) Keep in can for next time use. 保留以备下次使用 B) Put to wastebasket 倒入垃圾桶 C) Keep in stock in glass that later can destruction of reagent 存放在玻璃容器中再将其销毁 Mould start up 1. Where technician can find out all needed information regarding tool and injection molding parameters. 技术员在哪里可以找到关于模具和注塑成型参数的信息? a) From tool room. 模房 b) From Molding tool folder. 模具文件夹 c) From molding supervisor. 模具主管 2. Which documents and systems technician use for guide when he prepare and set mold and parameters in Standard molding cell where is already produced same product with same tool earlier? 一套模具在同一机台生产过,技术员通过什么文件或系统可以设置参数开机? 1. SAP Production order SAP生产指令 2. COR_07.13.01-01_Standa