森海ME-300规格书.docVIP

SPECIFICATION FOR EARPHONE 結構 Structure 編號NO 項目ITEM 規格 SPECIFICATION 1-1 尺寸 Dimension 請見附圖 Showed in attached “Exterior View Drawings” 1-2 凈重量 Net weight 15±2克 15±2 g 2.耳機規格 Headphone specifications (speaker) 電气規格(喇叭)Electrical specifications (speaker) 編號NO 項目ITEM 規格SPECIFICATION 2-1 尺寸 Size 喇叭尺寸=15毫米 Dimension/inner speaker=15mm 2-2 阻抗 Impedance 32Ω+20% 32ohm +20% 2-3 振動片 Mylar 9μ 2-4 輸出音壓 Out put sound pressure level 115+3dB(1千赫兹 1毫瓦 受力時) (輸入電壓=300mV) 115+3dB(when inputting 1 kHz 1mw) (V-input=300mV) 2-5 頻率響應 Frequency response 20赫兹~20千赫兹(圖1) 20Hz~20KHz(Show in figure1) 2-6 額定輸入功率 Rated input power 3毫瓦 3 mW 2-7 最大輸入功率 Max rated input power 5毫瓦 5mW 2-8 存贮温度 -25～70℃ From -25 to 70℃ 2-9 工作温度 Operation temperature -10～70℃ From -10 to 70℃ 2-10 保存湿度 Storage humidity 40℃ 95﹪以下 95﹪ or less when it is 40℃ 2-11 工作 Operation 操作過程中音量、音質無異常 No strain in sound volume and sound quality 2-12 左右感度差 Sensitivity difference Between left and right 3db以内（1KHz 1 m W 受力時） Within 3dB (when inputting 1 kHz l m w ) 2-13 相位 Phase 左右SPK都應處在正相位 Both the left and right should be in positive phase 2012-7-2 Page: 3/9 SPECIFICATION FOR EARPHONE 3. 可靠性實驗 Reliability test 編號NO. 項目ITEM 規格SPECIFICATION 3-1 彎曲實驗 Bending test 項目 Item 重量 Weight 角度 Degree 每分鐘次數 Times per minute 次數 Number of times 連接耳殼与導線(圖a) Between speaker box portions and cord (fig.a) 100g +60° 20 1000次以上 or more 連接插頭与導線(圖b) Between plug and cord (fig.b) 100g +60° 20 1000次以上 or more 線檔與導線(圖c) Strain relief and cord (fig.c) 100g +60° 20 1000次以上 or more 線檔與導線(圖d) Strain relief and cord (fig.d) 100g +60 20 1000次以上 or more 3-2 振動實驗 Vibration Resistance 置於振動試驗機中（10～55Hz，振幅:2.0mm),於三面方向施加規定之振動1小時後無損傷。 No any defaults are found after vibration for 1 hour. In each three orientations at vibration (10~55Hz) with 2.0mm P-P amplitude. 2012-7-2 Page:4/9 SPECIFICATION FOR EARPHONE 編號NO. 項目ITEM 規格SPECIFICATION 3-3 拉力實驗 Pull test 在線材伸張方向用1.5kg拉力,持續60秒.