Power consumption.pptxVIP

Power Consumption -guideline Yang, boPower ConsumptionContentsEquipmentTest casesTest case settings Submitting an issueCatch logUseful linkRequired equipmentAnritsu network simulator 8475 (the name of network is called TEST PLMN11)Powerbox (preferably TTi PL154 to be able to use sense)Multimeter Agilent 34410APhone with Anritsu SIM and 8GB SD card with test content1.2.5 Band phones for some test cases (ATT UMTS)RF antenna x 2Connect the PhoneWith Aoba as an exampleThere are 2 RF antennas in Aoba, such as below:Connect the equipmentConnecting the equipment From the dummy battery’s red cord connect a Black cord to the “LO” to the right on the MultimeterFrom the dummy battery’s black cord connect a black cord and connect it to the black contact on the PowerboxOne cord from the red contact on the Powerbox to the lower right red cord connect on the Multimeter.USB cable from the multimeter to the computerOn the PowerboxCurrent can be on max the entire timeVoltage shall be on 3.85Ampere shall be on 1250mAOn the Multimeter(Agilent 34410A)Power on the MultimeterPress “Shift” button then press “DC V” buttonPress “Range+” button Select “3 A” On the AnritsuStart the app MX847570A (yellow icon)Select Simulation Parameter Setup (upper left corner)Choose what type of network you want to test from the dropdown menu Simulation Model L01 = LTE, G01 = GSM, W01 = WCDMA/UMTS and press OKLoad a test case in Cell parameterChoose a test case (for example GSM idle) from the drop down menu in the BTS1 tab to the right and press ApplyPress PLAY Wait for ”Power Off” to lit and then start the phoneWhen ”Idle” is lit you are connected. Always double check on the phoneOn the AnritsuOn the AnritsuDC Measurement settingsAfter connecting the equipment, install the DC Measurement software. This should also contain the drivers needed for the Multimeter. If not, install the drivers that came with the Multimeter/In order for this program to work you must first ensure that the dot (.) is used as De