温控说明书.docxVIP

温控器接线图POWER UP PROCEDURE启动程序Verify all electrical connections have been properly made before applyingpower to the instrument.If the instrument is being powered for the first time, it may be desirable todisconnect the controller output connections. The instrument will be intocontrol following the power up sequence and the output(s) may turn ON.During power up, a self-test procedure is initiated during which all LEDsegments in the two front panel displays appear and all LED indicators areON. When the self-test procedure is complete, the instrument reverts tonormal operation如果仪器首次被驱动的,它可能要断开控制器输出连接。仪器会进入控制启动序列和后输出)可能打开。在启动期间,自测过程启动期间所有LED。自测过程完成后,仪器返回正常的操作。.Note: A delay of about 3 seconds, when power is first applied, will beseen before the displays light up注意:延迟约3秒,当电源是第一次应用,将见过显示点亮.3.1.2 KEYPAD OPERATIONAUTO/MANUAL KEYThis key is used to:1. Enter the Auto/Manual mode and vice versa.2. Used to activate the Auto Tune mode.3. Used to confirm a change in the Program mode.自动/手动键这把键是用来:1。进入自动/手动模式,反之亦然。2。用于激活自动调整模式。3。用来确定程序模式的改变SCROLL KEYThis key is used to:1. Select adjustment of the ramping setpoint, if enabled.2. Select a parameter to be viewed or adjusted.3. Display enabled modes of operation.4. Display a mode parameter value.5. Advance display from a parameter value to the next parametercode.6. Activate the Pre-tune mode.7. With the DOWN key to view the current Hardware Definition Codesetting滚动键这把键是用来:1。如果启用,选择调整增加定位点。2。选择查看一个参数或调整。3。显示启用的操作模式。4。显示一个模式参数值。5。提前从参数值显示到下一个参数的代码6。激活Pre-tune模式。7。在查看当前硬件定义的关键代码设置UP KEYThis key is used to:1. Increase the displayed parameter value.2. Increase setpoint.3. With the DOWN key to enter Pre and Auto Tune mode.上键这把键是用来:1。增加显示的参数值。2。增加定位点。3。用下键进入前和自动调整模式。DOWN KEYThis key is used to:1. Decrease the displayed parameter value.2. Decrease setpoint.3. With the UP key to enter the Pre and Auto Tune mode.4. With the SCROLL key to view the current Hardware Definition Codesetting下键这键是用来:1。减少显示的参数值。2。减少定位点。3。进入前的关键和自动调整模式。4。滚动查看当前关键硬件定义代码设置3.