408F电气系泊试验大纲(第一部分).docVIP

Contents 目录 MSB and ESB inspection and test 5 主配电板和应急配电板检验和试验 Sequential start test of auxiliary machinery/ Black out test 8 辅助机械顺序起动试验和失电试验 Starting test of largest motor on board Page 8 大功率马达起动测试 Auxiliary machinery emergency trip test 11 辅助机械紧急切断试验 AMS test Page 12 监测报警系统试验 Transformer Test Page 13 变压器测试 Test panel test Page 13 电工试验板测试 E/R Alarm Light column test Page 14 机舱报警灯柱测试 Normal lighting emergency lighting test 16 正常照明和应急照明试验 Navigation and signal lights test 20 航行信号灯试验 Dead man alarm test 22 死人报警试验 Charging discharging panel Page 23 充放电板试验 E/R Extend alarm test 26 机舱延伸报警试验 Distribution board test Page 27 分电箱测试 Before Testing - Check List. 试验前应完成的项目 1) Before Testing is commenced the following should have been carried out. 在试验前，下列项目应完成： All mechanical, electrical and structural inspections of the equipment should be completed before testing is started. 所有的机电设备，在试验前应检查。 Megger test should have been completed. 绝缘的测试。 All machinery, equipment, pipe systems including surrounding area to be properly cleaned before test. 试验前，相关的机器、设备以及周围的环境应适当的清洁。 The shipyard should have satisfactorily tested the equipment itself prior to the official test. 在报验前，船厂自己应正规地试验成功。 2) During Testing Procedure 在试验中 G) The detailed test procedure should be followed. 应根据试验程序详细试验。 H) The information from the test should be filled in on the system and pump motor data sheets 试验中的有关信息应填入相关的表格。 MSB/ESB inspection and test 主配电板/应急配电板的检查和试验 The following tests to be car