WQ说明书.docxVIP

摘 要本设计是关于平谷县第二污水处理厂的工艺设计。本工程根据平谷县城区的实际情况分二期建设。近期污水量为3.5×104m3/d，其中生活污水和工业废水所占比例约为1:1。远期污水量: 远期增加排放污水量1.5×104m3/d，预计增加污水量构成如下：1) 生活污水：0.4×104m3/d；2) 工业废水：1.1×104m3/d。总变化系数经内插法计算后得1.43。该污水的厂的进水的水质指标如下：COD=450mg/L，BOD5=170mg/L，SS=250mg/L，TKN =25mg/l，TP=4.5mg/l，T≥12oC,PH=7.6，总碱度：280 mg/L（以CaCO3计）。允许的出水水质指标如下：COD≤60mg/L，BOD5≤20mg/L，SS≤20mg/L，NH4+-N：≤ 2mg/L，NO3--N≤10mg/L，TP ≤1 mg/L,pH： 7～8。根据设计任务书的要求，本设计要考虑脱氮，因此选择的工艺必须能够进行氮的去除。所以本设计采用的是Carrousel型氧化沟工艺。本设计总共有7章。第1章介绍了设计依据及相关任务；第2章根据污水厂的设计要求对污水处理工艺进行了选择，并通过对比最终确定了Carrousel型氧化沟工艺。在接下来的3、4章里面，分别对各个构筑物进行详细的计算，并进行相应的设备选型。最后几章介绍了一些附属的设施。关键词：处理水量；水质指标；Carrousel 氧化沟。ABSTRACTIt is a preliminary design and construction drawing for the sewage treatment plant，which is placed in pinggu. Recent?sewage?volume?3.5 × 104m3 / d,?of which?domestic sewage?and industrial wastewater?proportion of?about 1:1.?Forward?sewage flow:?Forward?increase?the amount of sewage?discharged?1.5 × 104m3 / d,?is expected to increase?the amount of sewage?constituted?as follows:?1)?Sewage: 0.4 × 104m3 / d;?2)?industrial waste: 1.1 × 104m3 / d. The peak variatio factor is 1.43. The sewage plant influent water quality objectives are as follows: COD = 450mg / L, BOD5 = 170mg / L, SS = 250mg / L, TKN = 25mg / l, TP = 4.5mg / l, T ≥ 12 o C, PH = 7.6 The total alkalinity: 280 mg / L (as CaCO3). Allow the water quality indicators are as follows: COD ≤ 60mg / L, BOD5 ≤ 20mg / L, SS ≤ 20mg / L, NH4 +-N: ≤ 2mg / L, NO3 - N ≤ 10mg / L, TP ≤ 1 mg / L, pH: 7 ~ 8. The main requirment of the treatment is nitrogen removal in which a lot of treatment processes can make a good work. The Oxidition Ditch of Carrousel 2000 is choosed in the comparism of these processes which is choosed for nitrogen removal. There is 7 chapters in the design. In chapter 1, it is introduced that the information and the demand of the design. In the chapter 2, the Oxidation Ditch of Carrousel 2000 is choosed, which is compared with several processes with the function of the nitrogen removal. The structu