Basic course injection moulding.pptVIP

ProcesAfdelingen og Uddannelse p? Kornmarken * PC is used for bulletproof windows Tell again about the different in the structure! ProcesAfdelingen og Uddannelse p? Kornmarken * ProcesAfdelingen og Uddannelse p? Kornmarken * Developer formaldehyde fumes during moulding and degassing HV-POM = Low viscosity HI-POM = bigger shock, poor flowlines, and very expensive ProcesAfdelingen og Uddannelse p? Kornmarken * bottles for gasoline, hinge effect (the backs of books and trunk) ProcesAfdelingen og Uddannelse p? Kornmarken * PE-HD = bags (for fruit and vegetables) PE-LD = carrier PE, by combustion, only water Use a thin bag to show what direction the molecular chains are ProcesAfdelingen og Uddannelse p? Kornmarken * ProcesAfdelingen og Uddannelse p? Kornmarken * ProcesAfdelingen og Uddannelse p? Kornmarken * ProcesAfdelingen og Uddannelse p? Kornmarken * Explain the decompression – back pressure releases compression ”exceess pressure” decompression must equalize the pressure ProcesAfdelingen og Uddannelse p? Kornmarken * Show broken mould parts due to the pressure To see the picture, 60 tons correspond to 60 stacked cars. Having a pressure of 60 tons, it is necessary to keep the fluid plastics inside the mould ProcesAfdelingen og Uddannelse p? Kornmarken * As a warning ProcesAfdelingen og Uddannelse p? Kornmarken * Fixed pressure method: Typically for easy-fluid materials like POM and PA, as it is not possible to obtain 99% filling here. Holding-injection method: For tough material, typically PC: No automatical process regulation. PE: Typically ABS, automatical process regulation, easy running-in. ProcesAfdelingen og Uddannelse p? Kornmarken * Ulemper: hurtig fyldning ikke mulig pga. lav trykoverskud. h?jere lukketryk uegnet til st?rre emner st?rre sp?ndinger i emnerne. Fordele: ingen ekstra trykp?virkning, hvis emnerne h?nger. nem indk?ringsmetode. procesregulering er mulig. ProcesAfdelingen og Uddannelse p? Kornmarken * Ulemper: Risiko for overfyldt for