mud flowline and trip tank计量罐甲方要求.docVIP

Trip Tank SUBCONTRACTOR WILL provide, as part of the Rig Equipment, A Trip Tank that contains the Minimum Design Requirements shown below: The Trip Tank WILL have a minimum of Two Compartments; having a minimum capacity of 40 bbl 20 barrels each compartment . Each compartment WILL be equipped with a float-type internal graduated volume marker readable in 1/2 bbl increments at the tank site, and an air or electrical Tank Volume Totalizer system with remote volume read-out and recording devices located at the Drillers Console and in the Company Representatives office. Two centrifugal pumps, each capable of pumping a minimum of 4 BPM of freshwater 8.33 PPG Mud with 30 of Head to the BOP Stack Bell Nipple, WILL be installed. This pump capacity MUST be confirmed and demonstrated prior to drilling. The Centrifugal Pump Discharge s WILL be connected to both the Rigs mud tank using a 2 ID minimum size line, and the Bell Nipple using a 3 ID minimum size steel line. A 4 ID minimum size line WILL be used to allow mud returns from the Bell Nipple Flowline, to be returned to the Trip Tank for measurement. A 2 ID minimum size steel line WILL be provided to flow mud from the choke manifold into the Trip Tank. Fill-up lines, from the Rigs mud pumps, WILL be provided to allow selective filling of each Trip Tank compartment. Yes, As required the capacity of trip tank is 56.6bbl,two compartments 28.3bbl each compartment Trip Tank SUBCONTRACTOR’S TRIP TANK DESIGN CONFIGURATION Three are two trip pumps, two trip pumps are the parallel connection and any one can be a spare one if one trip pump has any problem. The trip suction mud from trip tank and transfer to the well by hose. When tripping out the hole, the trip pump can fill the well, when need fill mud into trip tank, we can use weighting pump to pumping mud from other tank through low pressure hoses. Mud Flowline and Downcomer SUBCONTRACTORs Flowline WILL be Flanged or Welded and of Sufficient Size, Slope, and Design