潜污泵规范要求.docVIP

edx2.5 PUMP ASSEMBLIES 水泵组件 A. Gveneral Requirements: 总要求 2. Pumps: Certify pump assemblies for the service, capacity and discharge head indicated on the Drawings. Mount pump assembly in accordance with the Hydraulic Institute standards. 水泵：保证水泵组件满足图纸上显示的服务、容量和输送压头。按照水力学学会标 准的要求对水泵组件进行安装。 3. Starters and Interconnecting Wiring: Refer to Section 260400, MATERIALS AND METHODS COMMON TO ELECTRICAL. 启动器和连接线路: 参见 260400节”电气常用材料和方法” B. Control Cabinet Assemblies: 控制箱组件 1. General: Provide factory assembled, wired and tested unit assemblies furnished in drip-proof, steel cabinets bearing labels indicating listed and approved service. 总则: 提供在防漏钢铁箱内配置工厂组装、连线和测试的组装单元，钢箱外有标签 列出明细和经核准的服务范围。 a. Provide a front mounted trouble alarm bell, alarm silence and an integral terminal block for extending wiring to remote pilot devices, starters and alarms for each pump zone set. 一个前置式事故报警钟、停止报警；一个整体接线盒，用于与每个水泵区 域的遥控指示装置、起动器和报警惊醒延伸接线。 b. For pumps in parallel, logic shall include an auxiliary timer to accommodate staggered pump starting, and include a selector switch to allow manual selection of the lead pump or automatically alternate the lead for the various pumps in the set. 平行的水泵,其逻辑控制应包括一个辅助计时器,用于调整水泵的交错启动; 并且还包括一个选择器开关, 以允许手工选择铅液泵, 或自动调整系统内 不同水泵的铅液。 c. Set floor mounted units on concrete housekeeping pads of not less than 150 mm in height. 楼面安装的单元必须安置在混凝土housekeeping垫上, 且垫的高度不少于 150mm 2. Pump Starters: Provide combined manual and automatic starter with front mounted circuit breaker and a mechanically interlocked isolating switch operable with the door open or closed. Include logic to remote signal conditions such as pump running, power failure, and trouble alarm. Initiate automatic starting through contacts from the system demand or basin level sensing logic devices. 水泵启动器：提供人工和自动组合启动器，带前置式断路开关, 以及1个机械互锁隔 离开关, 能够在门开启或关闭时运行。包括遥控信号条件的逻辑，例如水泵运行动 力失效、和事故警报。初始的自动启动通过接触系统需求或水池水位感应逻辑装置 发生。 a. Provide “Wye” Delta closed transition reduced voltage starters for pumps with motor power ratings