水厂泵类设备安装的质量与安全的讨论.docVIP

水厂泵类设备安装的质量与安全的讨论 摘要：泵类设备在水厂安装中的质量直接影响到整个生产系统的运行以及维护保养，其中，潜水泵和大功率离心泵以重量大，安装精度高显得最为重要。 Abstract: pump in water plant to install such equipment quality directly affect the entire production system operation and maintenance, among them, the high-power submersible pump and centrifugal pump with large weight, high installation accuracy is the most important. 关键词：质量 安全 Keywords: quality and safety 0 引言 0 the introduction 200QJ32-70/5潜水泵主要参数为：流量Q=32m3/s，扬程H=70m，转速n=2850/min，配套功率P=9.2KW，电泵运行总重1433Kg（含电机82Kg），最大外径185mm。 200 qj32-70/5 main parameters of submersible pump are as follows: flow rate Q = 32 m3 / s, lift H = 70 m, rotational speed n = 2850 / min, with P = 9.2 KW power, pumps running total weight 1433 kg, 82 kg (including motor), maximum outer diameter 185 mm. 整台设备分6大部分，其中除轴、叶轮及轴承等内部构件外，还输水管、吐出管、电机支座、轴承支座、电机等，总长度约为1749毫米。因潜水泵通常安装在室内，结合以上参数，可采用逐级起吊组对安装，即将各分段边吊上基础边逐级组对。 Whole device by six parts, including shaft, impeller and the internal components such as bearings, water hose, discharge pipe, motor bearing, bearing, etc., the total length is about 1749 mm. For submersible pump is usually installed in the indoor, combined with the above parameters, can be used to install lifting group, step by step is segmented on the basis while group to step by step. 逐级起吊组对安装即将长达1749mm的水泵外接管准确放进基础孔内，这样既减小了吊装高度，也使每次起吊的重量大大降低。 Step by step to install lifting group is 1749 mm water pump outside takeover accurately into the base hole, so that both reduced the hoisting height, also make each lifting weight is reduced greatly. 1 质量 1 the quality 1.1 质量方针： 1.1 quality policy: 精心安装，保证质量，科学管理，优质服务。 Carefully install, ensure the quality, scientific management, high-quality service. 1.2 质量目标： 1.2 quality objectives: 1.2.1 严控施工过程，确保每一个工序均达到规范及设备技术文件要求。 1.2.1 rein the construction process, to ensure that each process to meet the requirements of specification and the equipment technical documents. 1.2.2 质量验收一次合格。 1.2.2 a qualified quality acceptance. 1.3 质量措施 1.3 the quality measures 1.3.1 认真做好