Compsite Project 1 材料分析.docxVIP

Composite Project 1 Design and analysis of a laminated composite tubeName: Ren XiangStudent ID:7564590Date:25/03/2010Introduction:The main objective of this project is that design a cylindrical tube which should achieve the maximum angle of twist before the onset of any identifiable mechanisms of failure. To implement this winding angel was taken in account which is the main factor. The numerical software MathCAD was used in the design which was used for calculation the check.Requirement for the design:1. 4 layers of composite 2. Layup [α/β/α/β]. 3. Could sustain internal pressure of 3Mpa4. Co