Pressure test machine operation.docVIP

Pressure Test Machine Operation One, specimen of operation, 1, According to the requirements of experiment on specimen, rotation of the screw ,the upper pressing plate does not contact the specimen is limited, open the pressure machine, after rising cylinder, press [reset清零] key to clear tare. 2, The instrument was energized, or in the status of measurement press [parameter 参数] button to start the test . Instrument display: P0001 S----2 P0001 means the specimen number is 0001 1 is flashing S----2 refers to the test section of specimen code is 2 2 is flashing Section code 1, 2, 3, 4, 5, 6, 7, 8, respectively: 1 -- 100 x 100 x 100mm cubes 2 -- 150 x 150 x 150mm cubes 3 -- 200 x 200 x 200mm cubes Specimen 4 -- with arbitrary cross section 5 -- 150 x 150 x 150mm bending specimen 6 -- 100 x 100 x 100mm bending specimen 7 -- 40 x 40 x 160mm bending specimen 8 -- 70.7 x 70.7 x 70.7mm cubes According to the corresponding number keys, enter a 4 digit number, ;if need enter 0108, then input for: P0108 then press [confirmed确认] and then enter the cross section of the specimen, input 1 or 2, 3, 4, 5, 6, 7, 8 , if the user input into 4 sections when the actual input section, should be the value mm2 , such as the cross-section of 100 x 100mm should enter 10000 press [confirmed 确认] key then start the test. In the test without force, display serial and number in meter speed box, as shown in 108-1, said the current specimen serial is 0108, number is 1. Open the oil valve loading, force value exceeds 2KN instrument began to show force value, according to the requirement of rate control oil supply valve loading, until the specimen fracture, open the oil return valve, instrument automatically record the peak pressure, and saved to the memory, to join this serial specimens in the second test pieces, press [reset清零] button remove the last test force value, close the oil return valve, control oil supply valve loading until fracture of specimen, open the oil return valve, instrume