耐高温铝粉漆(500℃,NR606 Silver 银色 ).docVIP

Intended Uses 用途 耐热漆，适用于新建物的维修保养，保护温度可达500℃的铜材，可直接涂装于硅酸锌底漆上，喷砂后的钢材上，或经手工表面处理的钢材上。 Suited for new built construction and maintaince. It can protece steel subject to temperature high to 500℃, Directly paint over zinc silicate primer or steel blasted as well as manually steated Product Information产品简介 以改性有机硅树脂为基料的耐高温铝粉漆。 Based on modified silicone resin Application details 产品数据 Volume Solids 固体份 40% Dry Flm Thickness干膜厚度 35microns, equivalent 87 microns of wet film 35微米相当于87微米湿膜厚 Theoretical Coverage 理论涂布率 9.7m2 /Kg ,based on the stipulated volume silids and the dry film thick 25 microns. 9.7平方米/公斤,以规定体积的固体份和25微米干膜厚计 Practical Coverage 实际涂布率 Allow appropriate loss 允许适量损耗 Storage and Handling 施工详述 Mix Radio 混合比 One package 单罐装 Method of Application 施工方法 Airless Spray 无空气喷涂 Recommended 推荐采用 Brush or Roller 涂刷或辊涂 Suitable 适用 Conventional Spray 传统喷涂 Recommended 推荐采用 Thinner 稀释剂 In generals urnecessary. 一般不需要 Pot Life 使用期 Not limit 不限制 Storage 贮存期 One year 一年 Drying time 干燥时间 Substrate Temperature底材温度 Touch Dry 表干 （min） Hard Dry 硬干 （h） Over coating Interval 覆涂间隔 Mix最短 Max最长 25℃ 23℃ 35℃ 30minutes分钟 20minutes分钟 10minutes分钟 12hours 小时 8hours 小时 6hours 小时 16hours 小时 16hours 小时 12hours 小时 Not limit 不限 Storageand Handling 贮存与管理 Storage 贮存 Store in cool and dry conditions 贮存于阴凉干燥处 Pack size 包装规格 20Kg in 20 liter container 20公斤装于20公升容器中 Flash Point 闪点 ≥23℃ 高于23℃ Specific Gravity 比重 1.18Kg/L 1.18公斤/公升 Specification and Surface preparation 技术要求及表面处理 Substrate should be blasted or rust-removed manually to near to near white Wash with cleaner. The surface must be free from dirt such as grease, and salt ect . Surface to be applied must be clean and dry. 底材喷砂处理或手工除锈近乎出白 用清洁剂清理表面，无污物（如油污、油脂、盐类等） 在施工前应保持该表面清洁、干燥。 Safety Precautions 安全措施 This product should be used in painting area by perfessional operators. When painting , please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the p