J-link命令集.docxVIP

J-link命令集 Available commands are:----------------------f????????? Firmware infoh????????? haltg????????? goSleep????? Waits the given time (in milliseconds). Syntax: Sleep delays????????? Single step the target chipst???????? Show hardware statushwinfo???? Show hardware infomem??????? Read memory.?????????? Syntax: mem? Addr, NumBytes (hex)w1???????? Write? 8-bit items. Syntax: w1 Addr, Data (hex)w2???????? Write 16-bit items. Syntax: w2 Addr, Data (hex)w4???????? Write 32-bit items. Syntax: w4 Addr, Data (hex)wm???????? Write test words. Syntax: wm NumWordsis???????? Identify length of scan chain select registerms???????? Measure length of scan chain. Syntax: ms Scan chainmr???????? Measure RTCK react time. Syntax: mrq????????? Quitqc???????? Close JLink connection and quitr????????? Reset target???????? (RESET)rx???????? Reset target???????? (RESET). Syntax: rx DelayAfterResetRSetType?? Set the current reset type. Syntax: RSetType typeRegs?????? Display contents of registerswreg?????? Write register.?? Syntax: wreg RegName, ValueSetBP????? Set breakpoint.?? Syntax: SetBP addr [A/T] [S/H]SetWP????? Set Watchpoint. Syntax: Addr [R/W] [Data [D-Mask] [A-Mask]]ClrBP????? Clear breakpoint. Syntax: ClrBP? BP_HandleClrWP????? Clear watchpoint. Syntax: ClrWP? WP_HandleVCatch???? Write vector catch. Syntax: VCatch Valueloadbin??? Load binary file into target memory. Syntax: loadbin filename, addrSetPC????? Set the PC to specified value. Syntax: SetPC Addrle???????? Change to little endian modebe???????? Change to big endian modelog??????? Enables log to file.? Syntax: log filenameunlock???? Unlocks a device. Syntax: unlock DeviceName Type unlock without DeviceName to get a list of supported device names. nRESET has to be connected---- CP15 ------------rce??????? Read CP15.? Syntax: rce Op1, CRn, CRm, Op2wce??????? Write CP15. Syntax: wce Op1, CRn, CRm, Op2, Data---- ICE -------------Ice??????? Show state of the embedded ice macrocell (ICE breaker)ri???????? Read Ice reg.? S