2A充电器充电模块ETEK.docVIP

■ 实物： ■ 指标描述： DIVISION Test Condition SPEC EXT INPUT VOLTAGE TA CONNECT USB CONNECT DC 5.0V DC 5.0V Normal INPUT CURRENT TA CONNECT USB CONNECT 2000mA 500mA Normal BATTERY CHECK SAMSUNG ORIGINAL BATTERY 220? ~ 33K? BATTERY V/F SETTING VOLTAGE TA CONNECT USB CONNECT DC 4.35V ±0.03V DC 4.35V ±0.03V LOAD 100mA CHARGING VOLTAGE C.V MODE TA CONNECT USB CONNECT DC 4.35V ±0.05V DC 4.35V ±0.05V CHARGING CURRENT C.C MODE * TA CONNECT USB CONNECT 1900mA ±50mA 450mA ±50mA CHECK VOLTAGE 2.5V CHANGE CURRENT VOLTAGE TA CONNECT Below DC 4.4V CHARGING OFF FULL CHARGING VOLTAGE BATTERY VOLTAGE OVER 4.27V CUT OFF CURRENT BATTERY CURRENT 100mA ±20mA INPUT OVP DC INPUT OVER DC 6.0V MAX 12V CHARGING OFF LED OFF OUTPUT OVP BTC OUTPUT OVER DC 4.45V ERROR MODE MAX TIMER TA CONNECT USB CONNECT MAX 360min ±30min MAX 600min ±30min BATTERY VOLTAGE CHECK WAKE - UP 15secs ON, 1sec OFF, 10 Cycles UNDER DC 2.5V BATTERY VOLTAGE ESD TEST TEST VOTAGE ±8? Not allow auto reset Normal operation TEST VOTAGE ±15? Allow normal operation after artificial reset ■ LED指示 LED COLOR STATUS SIGNIFICATION RED ON Rapid charge Wake-Up Mode GREEN ON Termination charge fully charge Recharging Mode YELLOW ON Under the Thermal Protection No charge Low Temperature : -5 ~ -10℃ High Temperature : 45 ~ 50℃ YELLOW BLINKING NG battery, Error Mode OFF - Battery unloaded -.BATTERY CHARGER POWER ON RED- GREEN- YELLOW -.ERROR MODE 1 LED off : Battery unload Unable to sense V/F terminal 2 Yellow blinking : Battery Error, B+ GND short, B+ open, Over voltage error over 4.45Vdc , etc. ETEK 2A 充电模块