R1001N1规格书.docVIP

1．General Characteristics 1.1 Shape and dimensions In accordance with the outline and dimension drawing. 1.2 Operating temperature range －10℃～＋75℃ 1.3 Conserving temperature range －20℃～＋85℃ 1.4 Test conditions Ordinary temperature 5~35℃ Ordinary humidity 45~85℃ Ordinary atmospheric pressure 86~106kPa 1．一般特性 1.1 形状尺寸 见附图 1.2 使用温度范围 －10℃～＋75℃ 1.3 保存温度范围 －20℃～＋85℃ 1.4 测试条件 常温 温度5~35℃ 常湿 湿度45~85% 常压 气压86~106kPa 2．Mechanical Characteristics 2．机械特性 Item 项目 Measuring condition 测试条件 Specifications 规格 Rotation operation 回转操作 2.1 Total rotation angle 全回转角度 Angle of effective rotation 有效回转角度 270°±5° 2.2 Operating force 动作力 Measure the rotation torque 测试旋转力矩 10~100gf.cm 2.3 Lever Stop Strength 止档力矩 Measure when rotate to the tail-end by CW or CCW. 顺时针（或逆时针）旋到底测试 ≥0.8Kgf.cm 3．Electrical characteristics 3．电气特性 Item 项目 Measuring condition 测试条件 Specifications 规格 3.1 Rating 额定值 Power rating 70℃ 70℃时额定功率W 0.2W Max operating voltage virtual value of direct current or alternating current 极限电压（直流或交流峰有效值）V 200V Insulating voltage Max direct current or alternating current 绝缘电压（直流或交流峰值） 300V Item 项目 Measuring condition 测试条件 Specifications 规格 3.2 Total Resistance error 总阻误差 Measurement shall be made at 1、3 terminals of resistance. 在电阻体的1、3端测试 ±10%R 3.3 Residual resistance 残留电阻 Measurement shall be made separately when potentiometers rotate at 1 terminal and 3 terminal. 电位器旋至1与3端时分别测试 R1、2≤10Ω R2、3≤10Ω 3.4 Slider noise 滑动噪声 The residual resistance with the shaft lever placed at the end of terminal 1, shall be measured between the terminals 1 and 2. Next with the shaft lever placed at the end of terminal 3, the resistance shall be measured between the terminals 2 and 3. If there are tapped terminals, the shaft lever shall be turned moved and the resulting minimum resistance between the taped terminal and the terminal 2 shall be measured. 按照如图的测试电路测试，以每分钟2～5圈的速度转动旋钮。 ≤100mV 3.5 Insulation resistance 绝缘电阻 Measure to Apply DC250V. Betwe