商业建筑通信布线标准EIA568和EIA569(英文).docVIP

ANSI/TIA/EIA 568 StandardsANSI/TIA/EIA 569 Standards Structured Cabling Systems ANSI/TIA/EIA 568 COMMERCIAL BUILDING TELECOMMUNICATIONS CABLING STANDARD I. PURPOSEThis standard outlines specifications for a generic telecommunications cabling system. The purpose is to enable the planning and installation of telecommunications cabling with limited knowledge of the products that will be installed. This standard also establishes performance criteria for various system configurations and their elements. II. CABLING STRUCTURE The elements of a cabling system are listed below: A. Horizontal CablingB. Backbone CablingC. Work AreaD. Telecommunications ClosetE. Equipment RoomF. Entrance Facilities III. SCOPE This standard specifies cabling of commercial buildings which are office oriented. Typically, this includes sites of up to 3,000 to 1,000,000 M2with a population up to 50,000 users. IV. HORIZONTAL CABLING A. Horizontal cabling shall be of star topology, each work area connector shall be connected to a telecommunications closet. The maximum horizontal distance shall be 90 meters. An additional 10 meters is allowed for work area cables, patch cables, etc. B. Recognized Cables1. 4-pair 100 ? UTP cable2. 2-pair 150 ? STP cable3. 2-fiber, 62.5/125 um optical fiber cable C. Outlet/Connector A minimum of two telecommunications outlets shall be provided to each work area. The two outlets shall be configured as follows:1. One connector shall be supported by a 4-pair 100 ? UTP cable, Category 3 or higher2. The other shall be supported by a minimum of one of the following:a. 4-pair 100 ? UTP cable Category 5 recommended b. 2-pair 150 ? STP cablec. 2-fiber, 62.5/125 um optical fiber cable D. The amount of untwisting of individual pairs to terminate shall be less than or equal to .5 in. for Category 5 and less than or equal to 1.0 in. for Category 4. E. Cable bend radius shall not be less than 4 times the cable diameter. V. BACKBONE CABLING The purpose of ba