SINUMERIK 840D 设定系统上电初始状态.doc

SINUMERIK 840D: 设定系统上电初始状态： JOG-REF, JOG, MDA, AUTO etc. 问题:启动后，系统总处于回零操作方式。能设置为其他方式吗？如手动“JOG”方式。 回答:下述的机床数据可以定义系统启动后，每个方式组的初始状态： 通用数据：MD 10720 OPERATING_MODE_DEFAULT 启动后，方式组缺省的操作方式：BA 若PLC未选择任何操作方式，启动后方式组n的所有通道操作状态由参数OPERATING_MODE_DEFAULT[ n -1 ] 设定。 0 = BA? 自动方式（Automatic）1 = BA? 自动，REPOS 方式(Automatic,REPOS)2 = BA MDI3 = BA MDI，REPOS方式（MDI,? REPOS）4 = BA MDI，示教方式（MDI,? teach-in）5 = BA MDI，回零方式（MDI,? approach to reference point）6 = BA 手动方式（JOG）7 = BA JOG，回零方式（JOG,? approach to reference point）8 = BA 自动，示教方式（AUTO, teach-in）9 = BA 自动，示教，回零方式（AUTO, teach-in,? approach to reference point）10 = BA 自动，示教，Repos方式（AUTO,? teach-in,? Repos）11 = BA MDI，示教，回零方式（MDI,? teach-in,? approach to reference point）12 = BA MDI，示教，Repos方式（MDI,? teach-in,? Repos） 缺省值为7 若设为6，则上电后为手动状态。?条目号??? 日期:2009-03-27??QUESTION:After the ramp-up, the control is always in operating mode JOG in approach to reference point.How can one set another operating mode such as JOG? ANSWER:Initial state of machine after ramp-up defined in the following machine date for every mode group: Machine date 10720 OPERATING_MODE_DEFAULT Default operating mode (BA) of the mode groups (BAGs) after Power If the PLC does not select any operating mode, all channels assigned to mode group n are in the operating mode defined by OPERATING_MODE_DEFAULT[ n -1 ] after a Power ON: 0 = BA Automatic1 = BA Automatic, submode REPOS2 = BA MDI3 = BA MDI, submode REPOS4 = BA MDI, submode teach-in5 = BA MDI, submode approach to reference point6 = BA JOG7 = BA JOG, submode approach to reference point8 = BA AUTO, submode teach-in9 = BA AUTO, submode teach-in, submode approach to reference point10 = BA AUTO, submode teach-in, submode Repos11 = BA MDI, submode teach-in, submode approach to reference point12 = BA MDI, submode teach-in, submode Repos Default value is 7 Here, the value 6 could be set for BA JOG.??Entry ID??? Date:2009-03-20 SINUMERIK 840D: PLC系列备份文件的内容 问题：如何在存档文件（archive f