环氧玻璃鳞片涂料的用途和使用.docVIP

Intended Uses 用途 用于钢铁物件和水泥、混凝土作面漆或中间层，具有优异的耐水和耐化学品渗透，高附着力 和机械强度、既具有理想的防腐蚀性，又有一定的装饰性。 Used for steel construction, cement and concrete as finish or intermediate coat, It forms a coating with excellent resistance to water and chemicals, penetration, high adhesion and machanical stren- gth, The paint is possessed of both ideal corrosion resistance and good decoration. Product Information产品简介 白色、铁红色、淡灰色、淡绿色、天蓝色、桔黄色等等，二罐装 White, iron red, light grey, pale green, azure, orange yellow,etc Two packages Application details 产品数据 Volume Solids 固体份 ≥75-80% according to the color 视颜色而定 Dry Flm Thickness干膜厚度 150 microns equivalent to 185-200 microns of wet film maximum Up to 300um 150微米相当于185-200微米湿膜厚，干膜厚最大可达300微米 Theoretical Coverage 理论涂布率 3.3-3.7 m2 /Kg 3.3-3.7平方米/公斤 Practical Coverage 实际涂布率 Allow appropriate loss 允许适量损耗 Storage and Handling 施工详述 Mix Radio 混合比 A : B 25:3 by weight，it depends upon the practical Temperature ture 甲:乙 25:3 重量比，取决于实际温度 Method of Application 施工方法 Airless Spray 无空气喷涂 Recommended 推荐采用 Brush or Roller 涂刷或辊涂 Recommended 推荐采用 Conwentional Spray 传统喷涂 Not Recommended 不推荐采用 Thinner 稀释剂 C003，Maximum thinning:5% 最大稀释量5% Cleaner 油漆设备清洗剂 C003 Pot Life 使用期 25℃:2.5h Storage 贮存期 One year 一年 Drying time 干燥时间 Substrate Temperature底材温度 Touch Dry 表干 （h） Hard Dry 硬干 h） Over coating Interval 覆涂间隔 Mix最短 Max最长 20℃ 2 24 24hours 小时 7days 天 Storageand Handling 贮存与管理 Storage 贮存 Store in cool and dry conditions 贮存于阴凉干燥处 Pack size 包装规格 A;25Kg in 20 liter container 甲:25公斤装于20公升容器中 B:3Kg in 4 liter container 乙:3公斤装于4公升容器中 Flash Point 闪点 ≥27℃ 高于27℃ Specific Gravity 比重 Approx 1.45-1.50Kg/L 大约1.45-1.50公斤/公升 Specification and Surface preparation 技术要求及表面处理 The surface to be applied must be clean and dry 在施工前应保持清洁、干燥 Limitations 限制 Preceding coat: Epoxy glass flake anti-corrosive primer, micaceous iron oxide epoxy anti-corrosive paint etc. 前道配套涂料：环氧防锈底漆、环氧云铁防锈漆等 Subsequent coat: High-build epoxy finish. 后道配套涂料：厚膜型环氧面漆 Safety