基于AutoCAD真空助力制动器的设计可研报告.doc

天津工业大学 毕业设计（论文） 题目：基于AutoCAD真空助力制动器的设计 摘 要 真空助力器是汽车制动系统的重要部件，本文对对基于AutoCAD真空助力器的设计过程进行了详细的研究。国际现代汽车制动控制技术正朝着电子制动控制方向发展。全电制动控制因其巨大的优越性，将取代传统的以液压为主的传统制动控制系统。,往往是根据已有产品进行测绘或根据经验来完成,对其性能的评定,也只能是等实际产品制造出来之后,对其进行实验,才能得到各项指标。如果不满足要求,就需要进行局部修改或重新设计。显然,这要浪费很多时间,也不利于节约经济成本针对传统汽车零部件设计方法的局限性。本课题主要利用AutoCAD软件，将传统设计方法与计算机相结合,缩短了产品的开发周期,提高了产品设计的水平和质量。通过建图形库、表格以及巧用设计中心等一系列方法，提高了汽车制动器设计效率,缩短了产品的开发周期，节约设计经济成本。 关键词：真空助力器、AutoCAD ABSTRACT Automotive Vacuum Brake Booster is an important component of Automobile Braking Systems, this paper does detail the process of research about Automotive Vacuum Brake Booster based on AutoCAD. International modern automobile brake control technology is moving in the direction of the development of electronic brake control. Because the great advantages of all-electric braking control, it will replace the traditional brake control system which the main is hydraulic. At present, designing Automotive Vacuum Brake Booster have the main way at home. Imitate of surveying and mapping the vehicles on imported, and modified and design domestic vehicles against the practical demand, and obtain products adapted to the domestic vehicle braking systems. Design work of traditional Automotive Vacuum Brake Booster, often based on survey and mapping products or the basis of their experience .We can get the indicators after producting actual products and experiment them. If they are not satisfied with the demand, we must do local modification or re-design. Obviously, this should be a lot of time wasted, and don’t save the economic cost. The way of traditional automotive design has some limitations. The topics uses the software of AutoCAD, and combine the traditional design methods and computer to shorten the product development cycle and improve the level of product design and quality. Through building graphics and using design center, etc. we improve the design efficiency of the Automotive Vacuum Br