基于FPGA的ASK调制解调器的设计可研报告.docVIP

大连交通大学信息工程学院 毕 业 设 计 (论 文) 题 目 基于FPGA的ASK调制解调器的设计 学生姓名 刘师宇 专业班级 信息工程09-2 指导教师 徐佳 职 称　　 讲师 　 所在单位 电气工程系信息工程教研室 　 教研室主任 　 石桂名 完成日期 2013年 6月28日 摘 要 在科技高速发展的今天,作为现代通信系统的关键技术之一的调制解调技术一直是人们研究的一个重要方向。在数字传输系统中，数字信号对高频载波进行调制，变成频带信号，在接收端进行解调，恢复原数字信号对载波的控制,可使用振幅调制即振幅键控（ASK）。现场可编程门阵列（FPGA）在通信领域得到了广泛的应用，利用FPGA性能优越、使用方便的特点，可以简化振幅调制解调电路的设计，而且易于反复编写和修改程序。基于FPGA的ASK调制解调器具有外围电路简单，执行速度，等特点Quartus II软件进行仿真来实现基于FPGA的ASK调制解调器的设计，设计出相应硬件设计的电路图和软件设计并且得到仿真结果，完成了二进制基带数字信号的调制和解调得，到了相应的调制信号和解调信号，进而完成基于FPGA的ASK调制解调器的设计。 关键词：现场可编程门阵列 振幅键控 VHDL 调制解调 ABSTRACT In todays rapid development of science and technology. As one of the key technology of modern communication system of modulation demodulation technology has been research one of the important direction. In digital transmission systems, digital signal of high frequency carrier wave modulation, into a frequency band signal, carries on the demodulation in the receiving end, restore the original digital signal control of the carrier can use amplitude modulation amplitude keying (ASK). Field programmable gate array (FPGA) has been widely used in the field of communication, the advantage of the characteristics of FPGA is superior in performance, easy to use, can simplify the design of amplitude modulation demodulation circuit and easy to write and modify the program again and again. ASK a modem based on FPGA has the peripheral circuit is simple, high efficiency, execution speed, high practicability etc. Therefore, this article introduces the based on the VHDL language and ASK the related knowledge of learning, using VHDL language programming and the Quartus II software simulation to achieve ASK modem based on the FPGA design, design the corresponding hardware circuit diagram and software design and get the simulation results, complete the binary baseband digital signal modulation and demodulation, obt