Paralle Routing(平行Routing).docVIP

Parallel Routing Setting Date: 2008-12-23 Created by Jerry This documentation will illustrate how to set parallel routing operation in the BaaN V I Introduction In the BaaN V, the parallel routing operation can be carried out by adding phantom item into the BOM, please noted that you can only go this way to set the parallel routing operation in the BaaN V which we call it as Network Routing Operation. II How to setting Parallel Routing Operation In order to understand this way clearly we will build a BOM as below for example: Item Code Type Phantom UOM JERRY-TEST-FG1 M N 1 JERRY-TEST-Q3 P N 1 JERRY-TEST-Q4 P N 1 JERRY-TEST-Q1 P N 1 JERRY-TEST-Q2 P N 1 The routing operation as below: Operation Description Production Rate(/hour) Cycle Time (min) Next Operation Operation10 Pre-Assembly 1 60 Parallel 40 Operation20 Punching 3 20 30 Operation30 Bending 1.2 50 40 Operation40 Assembly 1 60 － Actually this is a single level BOM if we did not consider the parallel routing operation 10 and 20, for set them as parallel processing, we need to create two phantom items to cut this single operation line as two different lines, so the BOM should be modified as below: Item Code Type Phantom UOM JERRY-TEST-FG1 M N 1 JERRY-TEST-WIP1 M Y 1 JERRY-TEST-WIP2 M Y 1 JERRY-TEST-Q1 P N 1 JERRY-TEST-Q2 P N 1 JERRY-TEST-Q3 P N 1 After build this BOM in the system, we also need to build the routing operation for this two phantom manufactured parts. And for FG we have: Then we can create a production order for item JERRY-TEST-FG1: After calculated by system, the requested delivery date is at 16:23 on 23-12-08 based on the start date and the planning method. You can calculate by yourself to check this result which should be read from the operation duration as 60min+(20min+50min) or you can see as 60+60+10, remember that we have a parallel operation happened at operation 10 an