TALAS III 拆解保养.docVIP

FOX 36 mm TALAS III RC2拆解维修 Damper Cartridge RemovalRemove the 36 RC2 Topcap With a 2 mm hex key wrench, remove the hex screw on top of the red rebound knob. Unscrew—but do not remove—the damper topcap with a 32 mm 6-point socket. Be careful not to slip and damage the wrench flats. You may need to grind down the socket so that it properly grips the wrench flats on the topcap.Leave the topcap assembly on. Secure your fork so that the fluid inside of the fork does not spill out. Note:? ? After loosening the RC2 topcap assembly, you are now ready to remove the bottom nut on the damper, which will allow you to fully remove the 36 RC2 Damper assembly from the lower leg assembly. Place an oil pan underneath the fork before loosening the bottom nut. Make sure the topcap assembly is screwed in a few turns, as youll need to turn the fork upside-down to access the bottom nut. You wont want suspension fluid to spill all over your new Hush Puppies! Remove the 36 RC2 Damper Remove the black protective cap. Line up the bolt holes on the high and low-speed compression knobs. Using a 2 mm hex key wrench, loosen—but do not remove—the hex fixing bolt on the low-speed compression knob. When the fixing bolt is loosened enough, lift and remove the low-speed compression knob and set it aside. Using a 2 mm hex key wrench, loosen—but do not remove—the hex bolt on the high-speed compression knob. When the bolt is loose enough, lift and remove the high-speed compression knob and set it aside. Using a 15 mm socket, loosen the bottom nut three (3) full turns.Thread the black protective cap back onto the nut, this cap will protect the adjuster during the next procedure.Using a plastic faced hammer, gently strike the bottom nut to release the damper assembly.Holding the fork over an oil pan, remove the bottom nut and crush washer. If the crush washer isnt attached to the nut, check the bottom of the lower leg; it might be stuck there. Suspension fluid should flow out