各种LED驱动片.docVIP

意法半导体 ST 推出一款驱动电流高达80mA的24路恒流输出RGB LED驱动器STP24DP05。在一个7x7mm的TQFP48封装内，新产品效能相当于三个普通的8路输出驱动器。STP24DP05内置SPI端口提供精确的控制诊断功能。LED驱动器,包含有8x3位串进并出的移位寄存器,输出级有24个可调整的电流源,提供5-80mA恒定电流来驱动LED.电源电压可低到3V,输出电压可高达20V,主要应用在LCD屏显示器.本文介绍了STP24DP05的主要特性, 方框图和典型应用电路图. STP24DP05 24-bit constant current LED sink driver with output error detectionThe STP24DP05 is a monolithic, low voltage, low current power 24-bit shift register designed for LED panEL displays. The device contains a 8 x 3-bit serial-in, parallel-out shift register that feeds a 8 x 3-bit D-type storage register. In the output stage, twenty-four regulated current sources were designed to provide 5-80 mA constant current to drive the LEDs.The 8x3 shift registers data flow sequence order can be managed with two dedicated pins. The STP24DP05 has a dedicated pin to activate the outputs with a sequential delay, that will prevent inrush current during outputs turn-ON. The device detection circuit checks 3 different conditions that can occur on the output line: short to GND, short to VO or open line.The data detection results are loaded in the shift registers and shifted out via the serial line output. The detection functionality is activated with a dedicated pin or as alternative, through a logic sequence that allows the user to enter or exit from detection mode.Through three external resistors, users can adjust the output current for each 8-channel group, controlling in this way the light intensity of LEDs. The STP24DP05 guarantees a 20 V output driving capability, allowing users to connect more LEDs in series.The high clock frequency, 25 MHz, makes the device suitable for high data rate transmission.The 3.3 V of voltage supply is useful for applications that interface any micro from 3.3 V.主要特性:■Low voltage power supply down to 3 V■8 x 3 constant current output channels■Adjustable output current through external resistors■Short and open output error detection■Serial data IN/Parallel data OUT■Shift register data f