bk锂离子测试标准-安全测试.docVIP

1.0范围 SCOPE 本规范规定了邦凯锂离子电池定义、要求、测验方法、测试频次和数量； 本规范适用于邦凯公司所有的锂离子电池。 This criterion describes the definition, requirement, test method, test frequency and amount. This criterion only applies to Li-ion battery produced by BK. 2.0变更记录 CHANG RECORD 变 更 日 期 Chang date 版 本 Edition 变 更 内 容 Change content 2004-5-12 00/00 新版发行 new edition 2004-9-29 00/01 增加英文版 add English edition 2005-01-28 00/02 细化部分测试方法 add some test detail 2005-04-20 00/03 修改抽样标准 2005-06-29 00/04 增加聚合物测试 3.0引用标准 REFERANCE 下列是本文引用的标准。执行本规范时，所示版本均应该为有效版本。使用本规范的各部门应注意下列引用标准是否是最新版本。 There are the references in this document. The edition of references is valid edition. All of the department using this criterion should notice the edition of the references. GB/T2828-1987逐批检查计数抽样程序及抽样表（适用于连续批的检查） GB/T2829-1987周期检查计数抽样程序及抽样表（适用于生产过程稳定性的检查） GB/T2900.11-1988蓄电池名词术语 GB/T18287-2000蜂窝电话用锂离子电池总规范 4.0 定义 DEFINITION 4.1充电限制电压--电池由恒流充电转入恒压充电时的电压值. Limited charge voltage— the voltage of constant current switches to constant voltage when battery is charged. 编制 Prepared by 会签 Checked by 批准 Approved by 4.2标称容量—指电池在环境温度为25±2℃的条件下,以5h率放电至终止电压时所应提供的电量,用C5表示,单位为Ah(安培小时)或mAh(毫安小时). Rated capacity—under 25±5℃,65±5%RH,it means the capacity value of being charge by 5h ratio to cut-off voltage. The capacity value can be expressed with code C5. The unit is Ah or mAh. 5.0测试条件和要求 TEST CONDITIONS and REQUIREMENT 5.1测试条件 Testing conditions 除非测试项目另有规定,本规范中各项测试应在以下条件下进行. All of the testing is done on the conditions hereinafter, unless there is other requirement. 温度:25℃±2℃; 相对湿度:45%±20%;大气压力:86kPa—106kPa Temperature: 25℃±2℃;Related humidity: 45%±20%;Atmospheric pressure: 86kPa—106kPa 5.2测量仪表与设备要求 Requirement of the testing equipment and meter 测量电压的仪表准确度应不低于0.5级,内阻应不小于10kΩ/V. The precision of meter used to measure voltage is no less than degree 0.5, and equipment used to measure internal resistance is no less than 10kΩ/V. 测量电流的仪表准确度应不低于0.5级. 测量时间用的仪