02218冲压工艺及模具设计大纲.docVIP

高纲1154 江苏省高等教育自学考试大纲 02218 冲压工艺及模具设计 南京工程学院编 江苏省高等教育自学考试委员会办公室 一、课程性质及其设置目的与要求 （一）课程性质和特点 冲压工艺及模具设计课程是我省高等教育自学考试数控加工与模具设计专业的一门课程。该课程的主要任务是使应考者了解冲压工艺的基本理论和方法，掌握制订冲压工艺和模具设计的原则和方法，熟悉典型冲压模具的结构，具备对简单冲压件进行工艺与模具设计的能力。 （二）本课程的基本要求 a，试计算所需冲裁力。 五、识图题 如：判断图示模具类型，简述该模具的工作过程并标注各模具零件名称。 a special tool to measure half a point the rotor shaft runout and simultaneous measurement of two coupling flutter testing, it should meet the requirements. Install the coupling housings to ensure embedded rotor coupling within a concave shoulder, and rotor clearance meets the design requirements. 6.4, 6, wearing construction technology of generator rotors demonstration 6.4.6.1 construction preparation and conditions through the stator before loading check and confirm to confirm air tightness test of the stator and stator mechanical, electrical, instrumentation and control and other related work had been completed. Internal cleaning of stator, high power vacuum the surface of the stator. Stator and rotor magnetic Center drainage is complete. In conjunction with the quality, mechanical, electrical and other relevant persons to finally cleaning check the stator, which is clean and free of any debris. Worn rotors check and confirm confirm before loading the rotor air tightness test, electrical test work has been completed. In conjunction with the quality, mechanical, electrical and other relevant persons to finally clean the rotors checked, its interior is clean and free of any debris. By quality, mechanical, electrical and other professionals to conduct an examination of the rotor, confirm the wear condition of the rotor. Special equipment inspection and rotor through the preparation tool before loading inventory, check to confirm that it appears intact, complete tool, tools required for use of wire rope that has a factory certificate and test report; wire rope should select the safety factor ≥ 6; hoist testing qualified; road have been equipment auth