DM800使用说明书.docVIP

DM800操作说明书 机器起动完先按遥控:MENU菜单健,出来以下画面. 再按OK健,出来以下画面.选择频道搜索 再按OK健, 出来以下画面,选择调谐器配置 再按OK健: 出来以下画面,选择Tuner A:Alps BSBE2(DVB-S2) 高级再按OK: 出来以下画面, 先选择卫星.例如138KU出来以下画面. 下面是设置好的卫星参数, 1;(配置模式) 一般为高级. 2:(卫星) 看您要搜索哪个卫星.您就可以选哪个卫星.如138KU.那你您就选择138KU 3:(LNB) 这代表你的卫星是放在4切一第几口,如138KU在4切一第2口:那就先选择LNB2 4(次序) 一般为自动. 5:(LOF) 一般选择为用户自定义. 6:(LOF/L) 这个要看您用的是什么高频头:如用的是单本振就是11300,用的是双本振那就是:09750. 7:(LOF/H) 这个也要看您用的是什么高频头:如用的是单本振就是11300,用的是双本振那就是:10600. 8:(转折频率) 不需要改动 9(极化方式): 选择为极化. 10:(增加电压) 选择为否 11:(22K模式) 选择为自动. 13:(DISEQC) 模式)选择为1.1 14:(TOnebuest) 如4切一为1-2口先择为A.3-4口选择为B. 15:(Committed DISEQC命令) 如1口选择为AA. 2口选择为:AB. 3口选择为BA . 4口选择为BB 16:(快速DISEqC) 选择为否. 17:(重复序列) 选择为否 设置好保存按OK健:出来画面是再按OK健出来的画面是设置卫星146KU第3口画面.设置完成接OK健保存:回到了以下画面再按EXIT后退回到以下画面再选择自动扫描按OK健出现以下画面选择自动清理频道.按OK 操作完成:直动扫描OK a special tool to measure half a point the rotor shaft runout and simultaneous measurement of two coupling flutter testing, it should meet the requirements. Install the coupling housings to ensure embedded rotor coupling within a concave shoulder, and rotor clearance meets the design requirements. 6.4, 6, wearing construction technology of generator rotors demonstration 6.4.6.1 construction preparation and conditions through the stator before loading check and confirm to confirm air tightness test of the stator and stator mechanical, electrical, instrumentation and control and other related work had been completed. Internal cleaning of stator, high power vacuum the surface of the stator. Stator and rotor magnetic Center drainage is complete. In conjunction with the quality, mechanical, electrical and other relevant persons to finally cleaning check the stator, which is clean and free of any debris. Worn rotors check and confirm confirm before loading the rotor air tightness test, electrical test work has been completed. In conjunction with the quality, mechanical, electrical and other relevant persons to finally clean the rotors checked, its in