摘录不饱和聚酯文献中的经典句子.docVIP

1.To access the description of a composite material, it will be necessary to specify the nature of components and their properties, the geometry of the reinforcement, its distribution, and the nature of the reinforcement–matrix interface. 2. However, most of them are not chemically compatible with polymers 3. That’s why for many years, studies have been conducted on particles functionalization to modulate the physical and/or chemical properties and to improve the compatibility between the ?ller and the matrix [7]. 4. Silica is used in a wide range of products including tires, scratch-resistant coatings, toothpaste,medicine, microelectronics components or in the building 5. Fracture surface of test specimens were observed by scanning electron microscopy 6. Test specimens were prepared by the following method from a mixture composed with 40 wt% UPE, 60 wt% silica Millisil C6 and components of ‘‘Giral.’ 7. Grafted or adsorbed component amounts on modi?ed silica samples were assessed by thermogravimetric analysis (TGA) using a TGA METTLER-TOLEDO 851e thermal system. For the analysis, about 10–20 mg of samples were taken and heated at a constant rate of 10 C/min under air (purge rate 50 mL/min) from 30 to 1,100 C. 8. Nanocomposites with different concentrations of nanofibers were produced and tested, and their properties were compared with those of the neat resin. 9. Basically, six different percentages were chosen, namely 0.1, 0.3, 0.5, 1, 2, 3 wt %. 10. TEM images of cured blends were obtained with a Philips CM120 microscope applying an acceleration voltage of 80 kV. Percolation threshold of carbon nanotubes ?lled unsaturated polyesters 11. For further verification, the same experiment was carried out for the unmodified UP resin, and the results showed that there were no endothermic peaks 12. The MUP resin was checked with d.s.c, scanning runs at a heating rate of 10°C min 1. Figure 4a shows that an endothermic peak appeared from