12 危险源识及控制措施.docVIP

山东黄金绿苑房地产开发有限公司黄金集团荆山安置房供水工程危险源辨识及控制措施 1 目的 为了规范、加强给水安装工程危险源的安全管理，避免安全事故发生，保障施工生产和员工生命安全，制定本制度。 2 管理职责 2.1 生产部负责编制危险源安全管理制度，并组织相关部门及技术人员对公司给水安装施工中存在的危险源进行识别，编制规范的安全防护措施，对单项工程的专项施工方案和危险源防护措施进行审批，并进行日常的监控管理。 2.2 工程部负责组织本部门施工技术人员对单项工程的危险源进行识别，并根据单项工程的特点编制专项施工方案和危险源防护措施，并组织实施。 2.3 生产部负责编制重大危险源应急救援预案和演练方案建立危险源安全管理档案，主要包括以下内容：危险源管理制度；危险源管理与监控实施方案；危险源安全评价（评估）报告；危险源监控检查表；危险源应急救援预案和演练方案。存在事故隐患的重大危险源，立即整改；对不能立即整改的，必须采取切实可行的安全措施，防止事故发生，并及时报告重大危险源应急救援预案的各项措施，根据应急救援预案制定演练方案和演练计划，每年至少进行一次实战演练。 manufacturers drawings bolt fastened in the cylinder and outer cylinder. Cylinder cylinder in the drain pipe installation and measuring component leads. 6.4.4.3 blade carrier, partitions and lower installation check the sealing ring of the seal and springs, which shall conform to the technical requirements manufacturers drawings. Cylinder gasket on the mounting brackets supporting the Group assembled, the lugs shall be no Burr on the surface, and other debris. Department suite in place to measure surface and inner cylinder surface height difference, compared with the original values confirm the location. 6.4.4.4 lower bearing and thrust bearing installation clean bearing and bearing, thrust bearing joints, clean them with a thin layer of turbine oil, and then lifting it to bits. 6.4.4.5 high and middle pressure cylinder over it to the end for high pressure rotor and low pressure change flange gasket without connection unit rotors and rotor flange gasket connection and there is no connection, so the rotor in place cases, rotors in place must be high and middle pressure cylinder together with the Chamber over it to the end. Jack in the box that are installed on a push-pull device of adjusting the high and medium pressure cylinder to end over and around to set up indicators to monitor data, general data about the difference must not exceed 0.02mm. To prevent cylinder about out of sync over the situation, take the following measures: a over Jack uses the same pump, evenly. B left