ES-45A2送器检定系统.docVIP

第1章 概述 1.1 操作平台 系统要求：运行在Windows 98/Me/2K/XP 硬件配置：适用于IBM PC 486以上各档微机及兼容机，8MB或以上内存， 硬盘350M以上，VGA 彩色显示；具有光盘驱动器和一个串口 1.2 软件特点 　　　 采用面向对象编程技术，软件；；； 使 用 手 册 福州亿森电力设备有限公司 目 录 第1章　概述 1.1 操作平台…………………………………………………………………1 1.2 软件特点 ………………………………………………………………1 安装与运行 …………………………………………………………… 1 第2章 检定 2.1　通迅参数设置……………………………………………………………2 2.2 自动检定 ……………………………………………………………… 3 第3章 数据管理 3.1 数据查询 ………………………………………………………………7 3.2 数据打印 ………………………………………………………………8 3.3 数据删除……………………………………………………………… 第4章 帮助 4.1 帮助…………………………………………………………………… 9 第5章 附表 福州亿森电力设备有限公司 销售电话 manufacturers drawings bolt fastened in the cylinder and outer cylinder. Cylinder cylinder in the drain pipe installation and measuring component leads. 6.4.4.3 blade carrier, partitions and lower installation check the sealing ring of the seal and springs, which shall conform to the technical requirements manufacturers drawings. Cylinder gasket on the mounting brackets supporting the Group assembled, the lugs shall be no Burr on the surface, and other debris. Department suite in place to measure surface and inner cylinder surface height difference, compared with the original values confirm the location. 6.4.4.4 lower bearing and thrust bearing installation clean bearing and bearing, thrust bearing joints, clean them with a thin layer of turbine oil, and then lifting it to bits. 6.4.4.5 high and middle pressure cylinder over it to the end (for high pressure rotor and low pressure change flange gasket without connection unit) rotors and rotor flange gasket connection and there is no connection, so the rotor in place cases, rotors in place must be high and middle pressure cylinder together with the Chamber over it to the end. Jack in the box that are installed on a push-pull device of adjusting the high and medium pressure cylinder to end over and around to set up indicators to monitor data, general data about the difference must not exceed 0.02mm. To p