楼梯间理石铺贴术交底.docVIP

交底提要：地砖铺贴的施工准备、相关材料、机具准备、质量要求及施工工艺。 交底内容： 交底摘要：理石铺贴施工的相关材料、机具准备、质量要求及施工工艺。 交底内容： 交底摘要：理石铺贴施工的相关材料、机具准备、质量要求及施工工艺。 备注：1.平板出立板尺寸要求统一(测量部位:平板至上立板尺寸、平板至下立板尺寸)。2、墙面踢脚压平板（要求出墙统一）。3、立板压平板（侧面观看立板、平板标准统一） 交底人： 接底人： 技 术 交 底 工程名称：淄博先进陶瓷创新中心研发楼 施工单位：山东天齐置业集团有限公司 分项工程名称：楼梯间理石铺贴 交底日期： manufacturers drawings bolt fastened in the cylinder and outer cylinder. Cylinder cylinder in the drain pipe installation and measuring component leads. 6.4.4.3 blade carrier, partitions and lower installation check the sealing ring of the seal and springs, which shall conform to the technical requirements manufacturers drawings. Cylinder gasket on the mounting brackets supporting the Group assembled, the lugs shall be no Burr on the surface, and other debris. Department suite in place to measure surface and inner cylinder surface height difference, compared with the original values confirm the location. 6.4.4.4 lower bearing and thrust bearing installation clean bearing and bearing, thrust bearing joints, clean them with a thin layer of turbine oil, and then lifting it to bits. 6.4.4.5 high and middle pressure cylinder over it to the end (for high pressure rotor and low pressure change flange gasket without connection unit) rotors and rotor flange gasket connection and there is no connection, so the rotor in place cases, rotors in place must be high and middle pressure cylinder together with the Chamber over it to the end. Jack in the box that are installed on a push-pull device of adjusting the high and medium pressure cylinder to end over and around to set up indicators to monitor data, general data about the difference must not exceed 0.02mm. To prevent cylinder about out of sync over the situation, take the following measures: a) over Jack uses the same pump, evenly. B) left to set