《世界现代设计》考核大纲.docVIP

《》考大纲 课程编号：课程类别：总学时数：学 分： 考要求 二、考内容 三、考方式最终成绩为闭卷考试成绩和平时成绩为评判依据，其中考试成绩占0%，平时成绩占0%。四、教材及参考书目 教 材王受之.世界现代设计史[M].深圳：新世纪出版社，2004.参考书目： [1] 王受之.世界现代建筑史[M].北京：中国建筑出版社，2005. [2] 李砚祖.造物之美：产品设计的技术与文化[M].北京：中国人民大学出版社，2000. [] 凌继尧、徐恒醇.艺术设计学[M].上海：上海人民出版社，2006. [] [英]E.H.贡布里希著，范景中译.艺术发展史[M].天津：天津人民美术出版社，2001. Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe supports and hangers part plant product quality certificate for each variable spring supports, consta