商品房买卖合同印系统.docVIP

1:解压下载文件。得到三个文件 如下图 2：双击服务程序，在屏幕右下角出现如下图标，说明服务程序已启动。 3：双击 启动客户端，打开系统登录界面。首次打开客户端需大约5到十秒钟，请耐心等待，直到出现如下界面。 4：输入用户名名：admin 密码：admin 以及验证码。登录系统 5：登录后选择内容填写，修改相应的合同内容，修改完成后点击《保存模版》进行保存。 6：合同打印。选择所有打印页面，进行预览。 点击打印所要打印当前页面。 7：打印之前请将打印机的打印页首选项的默认纸张设为A3，方向设为：横向。如下图 8：理论上本系统支持所有A3幅面的打印机（包括针、喷墨、激光打印机）但是根据我们多年的实践经验。建议几选择A3幅面的喷墨打印机，并为打印机加装自动供墨系统。这将在打印速度和经济性上都达到最佳。同时我们为你推荐以下两种型号的喷墨打印机供你参考： Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe supports and hangers part pl