制取纯水超纯水方法和工艺流程.docVIP

制取纯水、超纯水的几种常用方法及工艺流程图 一、医药用纯化水工艺流程图 （医药纯化水设备工艺流程图） 医药纯化水设备用途： 　　大输液、水针剂水处理 　　口服液用水处理 　　医用无菌水及人工肾析用水处理二、食品、饮料行业用纯水处理工程 （食品、饮料行业纯水处理设备工艺流程图） 食品、饮料行业纯水处理设备用途：　　饮用纯净水处理　　矿泉水、山泉水处理　　茶饮料、果汁饮料生产用水处理　　社区、宾馆、机关管道优质供水处理　　白酒勾兑、啤酒生产用水处理　　乳品饮料生产用水处理三、电力锅炉补给水、精细化工超纯水处理系统  （电力锅炉补给水、精细化工超纯水处理系统工艺流程图）? 电力锅炉补给水、精细化工超纯水处理系统用途：　　锅炉补给水　　冷凝水　　循环冷却水　　化工生产用纯水四、电子超纯水系统 （电子超纯水系统工艺流程图）? 电子超纯水设备用途:　　计算机硬盘?　　　　　　显像管（ＬＥＤ、ＬＣＤ）　　液晶显示器　　　　　　集成电路芯片　　半导体　　　　　　　　线路板涂装、电镀、表面清洗纯水处理设备 （涂装、电镀、表面清洗纯水处理设备工艺流程图）? ? ? 涂装、电镀、表面清洗纯水处理设备用途：　　电镀涂装　　建材涂装　　家电行业涂装　　汽车行业表面涂装 center pin checks and anchoring the inner cylinder. According to While coupling alignment should keep oil out of cavity and locate the rotor axis neck raised are within the prescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feeler gauges fit into. Center coupling, condenser water filling and water-filled according to factory requirement. For coupling three supported rotor Center, the mouth under the coupling between the value should be as stipulated in the manufacturer, usually 0.15~0.25mm. In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and special lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings and rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisional bolt confirmed the positioning of the rotor size, as well as the coupling between the adjustment shim thickness accuracy, drawings to meet the technical requirements. Plane, cylindrical and clean the coupling bolt holes should be clean and without burrs, scrap iron and grease-free, relative position of the coupling according to the drawing requirements are. Coupling top screws, round distance apart, indicators to monitor movement of the aircraft, its v