CCNA第二学练习答案chapter10.docVIP

1 窗体顶端 Refer to the exhibit. When Router D is configured to use a link-state routing protocol and is added to the network, what is the first thing that it does to begin learning the network topology? It sends LSP packets to Routers B and C. It sends LSP packets to all routers in the network. It sends Hello packets to all routers in the network. It sends information about its directly connected neighbors to Routers A and E. It sends information about its directly connected neighbors to all routers in the network. It learns about its directly connected networks when its interfaces reach the up state. 窗体底端 2 窗体顶端 What two events will cause a link state router to send LSPs to all neighbors? (Choose two.) 30 second timer expires whenever the network topology changes immediately after the Bellman-Ford algorithm has run immediately after the DUAL FSM has built the topology database upon initial startup of router or routing protocol 窗体底端 3 窗体顶端 What is the final step in the link state routing process? successors are placed into the routing table SPF computes best path to each destination network LSPs are flooded to all neighbors to converge the network DUAL algorithm is run to find best path to destination networks 窗体底端 4 窗体顶端 What two statements correctly describe the link state routing process? (Choose two.) each router in the area floods LSPs to all neighbors all routers in the area have identical link state databases LSPs use the reserved multicast address of 224.0.0.10 to reach neighbors routing loops are prevented by running the Diffusing Update Algorithm (DUAL) Reliable Transport Protocol (RTP) is the protocol used by for the delivery and reception of LSPs 窗体底端 5 窗体顶端 Refer to the exhibit. What kind of information would be seen in an LSP sent from router JAX to router ATL? hop count uptime of the route cost of the link a list of all the routing protocol