报纸新闻报道策实践项目教学大纲.doc

《报纸新闻报道策划》实践项目教学大纲 实践项目代码： 适用专业： 总学时数： 学 分： 理论学时： 实践学时： 编制单位或执笔者：系教研室 编制时间：年月 一、二、教材与教学参考书1、蔡雯. 新闻报道策划与新闻资源开发［M］.中国人民大学出版社，2004.01. 2、赵振宇. 新闻报道策划［M］.湖北：武汉大学出版社，2008.05. 3、杨国秀. 人民日报春梅书系：新闻报道策划［M］.北京：人民日报出版 社, 2012.08. 4、刘海贵. 中国新闻采访与写作［M］. 上海：复旦大学出版社,2012.11. 5、郑兴东. 报纸编辑学教程［M］.北京：中国人民大学出版社,2001.12. 、大纲编制说明 实践项目教学大纲执行审批表 大纲名称 项目编号 适用专业 总学时数 学 分 编制人 编制时间 课程负责人意见 课程负责人签章： 年 月 日 教研室 意见 教研室主任签章： 年 月 日 教学系 意见 系主任签章： 年 月 日 教务处 意见 教务处处长签章： 年 月 日  center pin checks and anchoring the inner cylinder. According to While coupling alignment should keep oil out of cavity and locate the rotor axis neck raised are within the prescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feeler gauges fit into. Center coupling, condenser water filling and water-filled according to factory requirement. For coupling three supported rotor Center, the mouth under the coupling between the value should be as stipulated in the manufacturer, usually 0.15~0.25mm. In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and special lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings and rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisional bolt confirmed the positioning of the rotor size, as well as the coupling between the adjustment shim thickness accuracy, drawings to meet the technical requirements. Plane, cylindrical and clean the coupling bolt holes should be clean and without burrs, scrap iron and grease-free, relative position of the coupling according to the drawing requirements are. Coupling top screws, round distance apart, indicators to monitor movement of the aircraft, its value is allowed to pass the value axis moving, mounted adjustment pads, note pads