机械与汽车工程院教材征订汇总表.doc

附件2： 合肥工业大学 学年第学期教材征订汇总表 学院: 2010 年 月 日 冲压工艺及模设计西北工业大学吴诗惇2002-1-1 2009-7-1 机制07，1-3 2 135 计算机辅助制造 选 4 CAD/CAM 技术(第２版)solidworks 2007曲面建模实例精解注：1. 为今后本科教学评估需要，请各系（教研室）认真填写教材征订单中每项内容，尤其是出版时间。 2. 由分管教学院长签字并加盖学院公章，一式三份，一份学院留存，另两份由教学秘书于6月7日前报送教务处教学研究科及后勤集团教材服务中心各一份（同时提交电子文档至教务处教学研究科）。 center pin checks and anchoring the inner cylinder. According to While coupling alignment should keep oil out of cavity and locate the rotor axis neck raised are within the prescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feeler gauges fit into. Center coupling, condenser water filling and water-filled according to factory requirement. For coupling three supported rotor Center, the mouth under the coupling between the value should be as stipulated in the manufacturer, usually 0.15~0.25mm. In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and special lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings and rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisional bolt confirmed the positioning of the rotor size, as well as the coupling between the adjustment shim thickness accuracy, drawings to meet the technical requirements. Plane, cylindrical and clean the coupling bolt holes should be clean and without burrs, scrap iron and grease-free, relative position of the coupling according to the drawing requirements are. Coupling top screws, round distance apart, indicators to monitor movement of the aircraft, its value is allowed to pass the value axis moving, mounted adjustment pads, note pads installation direction guide pin coupling with process end closed. The back wheels slowly tightened, when 2mm or so, with standard whit