剖视图讲课教学计--李继明制作.docVIP

《剖视图》教学设计 机电科 李继明 设计摘要 教学题目 《剖视图》 课 程 机械制图 学时安排 1课时 年 级 2014级机电班 所选教材 中国矿业大学出版社 刘胜利主编 一、设计依据 为了满足课程改革要求，依据机械制图课程标准创设一个融合多种教学手段和教法方法于一体的课堂环境，以该如何表达机件的内部结构作为切入点，结合教学模型和多媒体工具，多角度地演示剖视图图的作用、概念名称和形成过程；通过四字口诀“剖、移、画、标”和补画漏线练习，引导学生深刻理解剖视图的画法和标注，培养学生的空间想象能力，最终让学生能够绘制外形简单且结构对称型的组合体的剖视图。 二、学习目标与内容 1．学习目标 知识目标：情感目标： 激发学生学习兴趣，提高自信心， the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest the thickness. Once the lifting cylinder measurement of surface and in