实验六 触器逻辑功能测试及应用.docVIP

实验六 触发器逻辑功能测试及应用 一、实验目的： 1、掌握基本RS、JK、D、T和T′触发器的逻辑功能； 2、学会验证集成触发器的逻辑功能及使用方法； 3、熟悉触发器之间相互转换的方法。 二、实验原理： 触发器：根据触发器的逻辑功能的不同，又可分为: SR锁存器、脉冲触发的触发器、边沿触发的触发器、电平触发的触发器。 三、实验仪器与器件： 实验仪器设备：D2H+型数字电路实验箱。 集成块：74LS112 74LS74 74LS04 74LS08 74LS02 74LS86 四、实验内容与步骤： 1、基本RS触发器逻辑功能的测试： Qn+1 S+RQ , SR 0 为约束项 电路图为： 示波器如图： 2、JK触发器逻辑功能测试：Qn+1 J Qn + K Qn 电路图为： 示波器如图： 3、D触发器逻辑功能测试： 示波器如图： 异步输入端功能测试： 示波器如图： D触发器逻辑功能测试： 示波器如图： 4、不同类型时钟触发器间的转换： JK转换为D触发器： 示波器如图： D转换为JK 触发器： 示波器如图： JK转换为T触发器： 示波器如图： T转换为JK触发器： 示波器如图： JK转换为RS触发器： 示波器如图： RS转换为JK触发器： 示波器： 五、实验体会与要求： 1、根据实验结果，写出各个触发器的真值表。 2、试比较各个触发器有何不同？ 3、写出不同类型时钟触发器间的转换过程。 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when