又开始玩50Wx 2的D类功放——STA508.docVIP

自从做了老三洋6.5寸全频音箱后，感觉TA2020推不满标定功率为30W的喇叭，于是做了这款50W*2的功放。电路前级采用Tripath公司的TC2000，后级放大选用意法半导体的STA508芯片。电路选料采用了ALPS电位器、板载散热器、松下FC 1800uF*2水塘电容、西门子3.3uF大蓝色方块耦合电容、WIMA薄膜电容6等。电路设计了输出直流精密校准电路、喇叭保护电路、开机延时和输出保护功能。在直流30V单电源的推动下，能输出50W*2的不失真功率（8欧）。声音还是TA2020的走向，低频更有力，中频更加醇厚。与2A3胆机相比，高频细腻胜出10%以上，中频密度稍逊5%左右，低频的推动力相当。板子目前裸奔，正在定做复古机壳…… 508－1.jpg (32.37 KB) 下载次数:1 2010-11-9 00:13 508－2.jpg (28.53 KB) 下载次数:1 2010-11-9 00:13 TC2000.jpg (46.31 KB) 下载次数:0 2010-11-9 00:23 STA508内部电路.jpg (56.32 KB) 下载次数:1 2010-11-9 00:23 定做的机箱来了…………D类功放中的“胆机”！拉丝不锈钢板、实木护边！机箱尺寸：22*16*5.5cm??（不含护木） 100_4880.JPG (46.29 KB) 下载次数:0 2010-11-11 00:12 调整大小 100_4873.JPG (38.95 KB) 下载次数:0 2010-11-11 00:12 调整大小 100_4875.JPG (38.35 KB) 下载次数:0 2010-11-11 00:12 and performance test copies of the record. If necessary, review should be carried out; 4) for spring hangers (included simple spring, hangers and constant support hangers) it should also be recognized as setting and locking of loads. 5) check the surface quality, folded layering and without cracks, rust and other defects. 5) after completion of the test and control drawing number one by one, by series baled. Color alloy steel parts, the parts marking installation location and rotation about the direction you want. 7.3.14. hangers installation 7.3.14.1 hanger layout a. a clear design of hanger should be installed strictly in accordance with the drawings and designs shall not be installed wrong, missing, etc. B. own arrangement of piping support and hanger set and selection should be based on comprehensive analysis of general layout of piping systems; cold installation of steam pipe with particular attention reserved for compensation of thermal expansion displacement and orientation. C. support systems should be rational to withstand pipe loads, static load and incidental load; reasonable piping displacement; guaranteed under various conditions, stress are within the allowed range. Strength, stiffness, and meet requ