天行者X-8安装册(简体中文翻译版).docVIP

Skywalker X-8 Installation Manua 天行者X-8安装手册 （汉化版） 翻译 ---- China·天奇 Thank you for Purchasing the Sky- walker X-8 Plane. The skywalker X-8 is designed for First-Person-Vision(FPV) application specifically. 感谢您购买天行者X-8飞翼型飞机。天行者X-8是专为第一人称飞行（FPV）而设计的。 Technical parameters Wingspan：2120mm weight 880G motor 2820 KV730 speed regulator 60A battery pack 4S8000MAH propeller 12X6~13X8 技术参数： 翼展：2120mm 空机重量880克 电机2820 kv730 电子调速器60A电池组4s 8000mah螺旋桨12x6 ~ 13x8 Take-off weight ：3200G 设计最大起飞重量：3200g KIT version configuration：Fuselage, wing, winglet , tube, accessories bag, sticker 包版本的配置：机身，机翼，翼梢小翼，碳纤维管，配件袋（包含，胶水、拉杆、螺丝、层板、舵角、舵机延长线、强磁铁），贴纸 Parts Listing 零件清单：如图 Assembly Glue the winglet layers, spread the glue evenly over the wing and both sides of the layers ( the layer marked with T board belongs to parts of the main wing ) 安装说明： 翼梢小翼层胶，涂胶均匀，两侧翼的层（层在标有T板属于主翼部分） Wait for 5 minutes to allow glue to dry until it is non-sticky, then they can be glued in alignment , 等待5分钟让胶干直到不粘腻的，然后他们可以粘在对准 Glue the hatch magnets , after compressing the magnet tightly, fix them with CA glue. 胶舱口的磁铁，磁铁牢牢固定压缩后，用快干固定胶如 401胶水或 502胶水。 Glue the wood chip onto the hatch and fuselage, pay attention to the direction of SN of the magnetic pole 胶合木片上舱和机身，注意S/N磁极的方向 After gluing, put it together and inspect the mounting spacing 涂胶后，把它放在一起，检查安装间距 Glue the servo, please choose the standard servo provided by skywalker or servo with moment more than 2.5 KG 胶伺服，请选择由天行者或伺服安装力矩超过2.5公斤标准伺服 Glue the rudder horn, spread the glue evenly and wait for its dryness, then Glue the rudder horn 舵角胶，涂胶均匀，待其干燥，然后将舵角插入到副翼预留空位 Power on the servo and place it in the mid-position , then lock the regulator screw, tighten the steel wire. And shorten the extra length of the wire. 在中间位置放入伺服舵机，并锁紧调节螺钉，拧紧钢丝。缩短额外舵机导的线长度。 Glue the fixed layer of the winglets, please be sure to spread the glue evenly and wait until it is