360安全卫士装卸载手册.docVIP

卸载360安全卫士 1.打开“我的电脑”点击“卸载或更改程序”。 2.在程序列表中找到“360安全卫士”点击“卸载/更改”。 3.选择最后一项“我要直接卸载360安全卫士”点击“开始卸载”。 4.在弹出的对话框中点击“是”。 5.“360安全卫士”开始卸载。 6.点击“下一步”。 7.选择“否，稍后我自行重新启动”点击“完成”，完成卸载。 安装360安全卫士 1.右键点击“360安全卫士”安装包点击“以管理员身份运行”。 2.点击“自定义安装”，切忌点击“立即安装”。 3.修改“360安全卫士”安装路径，切忌安装在C盘下，取消所有复选框，点击立即安装。 4.开始安装。 5.务必取消掉“推荐安装’360安全桌面’”复选框，点击“完成”。 6.“360安全卫士”会弹出“立即加速”的广告窗口，务必点“×”关闭。 7.特别注意！“360安全卫士”第一次运行时会进行首次“体检”。其中“发现您的桌面图标数量过多，影响工作效率”建议“整理”的按钮千万不要点，否则会安装上“360安全桌面”。 8.安装“360安全卫士”后每次重启电脑的时候会有“开机时间”的提示，务必不要点击“5秒下载即玩”的按钮，否则会安装上“征途2”内核的网络游戏，对您工作造成不便。 9.打开“360安全卫士”的时候会有“新版特性”提示，务必点击“×”，否则会安装上“360产品” coupling Centre shall be checked, the second poured concrete strength of more than 70%. In the process of reaming or boring, apart from the special provisions in factory, does not allow any work that may affect the coupling Centre, such as irrigation, to cylinder connections to flood the condenser pipes and so on. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Mounting bolts should be added lubricants, typing gently with a small hammer, not too loose or too tight, packed the bolts with the corresponding seal screw hole should be marked. 6.4.5.4.2 coupling reamed and pairings is close to the diameter of bolt bearing good hinge holes, dressed with a good two coupling bolts before you can move the rotor, boring-reaming hole in turn. Coupling bolts must be tight coupling is symmetrical diameter, in boring, reaming, two bolts out. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Due to the coupling bolts in accordance with hinge holes corresponding to the diameter of the screw holes one by one after processing, processing back bolt installation location cannot be changed, so according to bolt after the actual weight difference of nut and lock washer to match. General requirements for coupling two symmetrical diameter bolt, nut and lock washers total weight difference should not be greater than 10 g and