UBNT300双极化客户端接收设置操作流程,有图。.docVIP

客户端接收设置操作流程 第一步：给电脑添加一个192.168.1.x的网端 右击电脑桌面上的“网上邻居”-----“属性” 右击“本地连接”--------“属性”-----双击下图中“Internet协议（Tcp/IP）”红线内容 双击后出现下图，按照图中标示填写即可 点击“确定”一路下来都点确定就好了。 二、添加完网段后就可以访问接收端了，我们来看一下如何设置 打开浏览器在地址栏中输入 192.168.1.20（这个是客户端的默认地址）回车后出现客户端登陆框 输入如下内容就可以进入： 默认的用户名和密码都是“ubnt” 进来后要选天线信号点标签的第二项下的Select 进去后就是信号搜索窗口 选择哪个信号最强的天线，我的是最下面红圈里的最好选后点Lock to AP后，会回到第二项的界面点下面的Change（更改） 出现下图点“应用” 这时客户端会重新启动一次。之后再选第一个标签看看信号 要说明的是信号质量一般要控制在-70以下。这个需要调整客户端的方向来调整到最好效果就可以了。 三、修改户端IP 选择第三项进行修改 填写完成后，点右下角的“更改” 点击后，上面点“应用”重启客户端就好了。设置完成。 coupling Centre shall be checked, the second poured concrete strength of more than 70%. In the process of reaming or boring, apart from the special provisions in factory, does not allow any work that may affect the coupling Centre, such as irrigation, to cylinder connections to flood the condenser pipes and so on. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Mounting bolts should be added lubricants, typing gently with a small hammer, not too loose or too tight, packed the bolts with the corresponding seal screw hole should be marked. 6.4.5.4.2 coupling reamed and pairings is close to the diameter of bolt bearing good hinge holes, dressed with a good two coupling bolts before you can move the rotor, boring-reaming hole in turn. Coupling bolts must be tight coupling is symmetrical diameter, in boring, reaming, two bolts out. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Due to the coupling bolts in accordance with hinge holes corresponding to the diameter of the screw holes one by one after processing, processing back bolt installation location cannot be changed, so according to bolt after the actual weight difference of nut and lock washer to match. General requirements for coupling two symmetrical diameter bolt, nut and lock washers total weight difference should not be greater than 10 g and knocks stamped mark. (See Figure 18) The coupling bolts apply lubricant, and th